Billy Goat OS551 User Manual

Download Owner's manual of Billy Goat OS552 Lawn and Garden Equipment, Lawn Mower for Free or View it Online on All-Guides.com. This version of Billy Goat OS552 Manual compatible with such list of devices, as: PR550H, OS551, OS551H, PR500HT, PR600S

Billy Goat OS552 Owner's manual - Page 1
1
Billy Goat OS552 Owner's manual - Page 2
2
Billy Goat OS552 Owner's manual - Page 3
3
Billy Goat OS552 Owner's manual - Page 4
4
Billy Goat OS552 Owner's manual - Page 5
5
Billy Goat OS552 Owner's manual - Page 6
6
Billy Goat OS552 Owner's manual - Page 7
7
Billy Goat OS552 Owner's manual - Page 8
8
Billy Goat OS552 Owner's manual - Page 9
9
Billy Goat OS552 Owner's manual - Page 10
10
Billy Goat OS552 Owner's manual - Page 11
11
Billy Goat OS552 Owner's manual - Page 12
12
Billy Goat OS552 Owner's manual - Page 13
13
Billy Goat OS552 Owner's manual - Page 14
14
Billy Goat OS552 Owner's manual - Page 15
15
Billy Goat OS552 Owner's manual - Page 16
16
Billy Goat OS552 Owner's manual - Page 17
17
Billy Goat OS552 Owner's manual - Page 18
18
Billy Goat OS552 Owner's manual - Page 19
19
Billy Goat OS552 Owner's manual - Page 20
20
Part No 350324 Form No F031108A
14
PR & OS Owner’s Manual
STORAGE
Never store engine indoors or in enclosed poorly ventilated areas with fuel in tank, where fuel fumes may reach an open
flame, spark or pilot light, as on a furnace, water heater, clothes dryer or other gas appliance.
If engine is to be unused for 30 days or more, prepare as follows:
Remove all gasoline from carburetor and fuel tank to prevent gum deposits from forming on these parts and causing possible
malfunction of engine. Drain fuel outdoors, into an approved container, away from open flame. Be sure engine is cool. Do not
smoke. Run engine until fuel tank is empty and engine runs out of gasoline.
Troubleshooting
When servicing engine refer to specific manufacturers engine owner's manual. Engine warranty is covered by the
specific engine manufacturer. If your engine requires warranty or other repair work contact your local servicing
engine dealer. When contacting a dealer for service it is a good idea to have your engine model number available
for reference (See table page 3). If you cannot locate a servicing dealer in your area you can contact the
manufacturers national service organization.
To reach:
American Honda: 800-426-7701
WARRANTY CLAIM PROCEDURE
Should a BILLY GOAT
®
machine fail due to a defect in material and/or workmanship, the owner should make a
warranty claim as follows:
The machine must be taken to the dealer from whom it was purchased or to an authorized Servicing BILLY
GOAT Dealer.
The owner must present the remaining half of the Warranty Registration Card, or, if this is not available, the
invoice or receipt.
The Warranty Claim will be completed by the authorized BILLY GOAT Dealer and submitted to their
respective BILLY GOAT Distributor for their territory Attention: Service Manager. Any parts replaced under
warranty must be tagged and retained for 90 days. The model number and serial number of the unit must
be stated in the Warranty Claim.
The distributor service manager will sign off on the claim and submit it to BILLY GOAT for consideration.
The Technical Service Department at BILLY GOAT will study the claim and may request parts to be
returned for examination. BILLY GOAT will notify their conclusions to the distributor service manager from
whom the claim was received.
The decision by the Technical Service Department at BILLY GOAT to approve or reject a Warranty Claim is
final and binding.
For online product registration go to www.billygoat.com
Problem Possible Cause Solution
Abnormal vibration. · Damaged or missing blades. Loose
handle bolts. Loose engine bolts
· Stop work immediately. Replace any
damaged or missing blades. Tighten all
loose nuts and bolts.
Engine stalls or labors when
raking
· Blades set too deep into ground. · Raise blades so that they just touch the
ground on a level surface
Engine will not start. · Stop switch off (Honda only). Throttle
in off position
· Check choke position.
· Out of gasoline or bad, old gasoline. · Check gasoline.
· Spark Plug wire disconnected. · Connect spark plug wire.
· Gas valve off. · Turn on gas valve.
· Dirty air cleaner. · Clean or replace air cleaner. Contact a
qualified service person.
Engine is locked, will not pull
over.
· Debris locked against reel, or drive
pulleys. Engine problem.
· Pull spark plug wire and remove debris.
Contact an engine servicing dealer for
engine problem s.