• Home
• Brands
• Billy Goat Manuals
• Billy Goat FM3300IN, FM3300INE
• Billy Goat FM3300IN, FM3300INE Operator Owner's Manual

Billy Goat FM3300IN, FM3300INE Operator Owner's Manual

Download Operator owner's manual of Billy Goat FM3300IN, FM3300INE Lawn Mower for Free or View it Online on All-Guides.com.

1

2

3

4

5

6

7

8

9

10

11

12

13

14

15

16

17

18

19

20

21

Part No. 520166 Form No. F112003A

Tools Required: 5/32” Allen wrench; 3/8” wrench.

1. Remove the spark plug wire.

2. Remove the belt deck cover.

3. Remove the brake spring (A) and control cable spring (B) (see

fi gure 17-10).

4. Remove the blade drive belt (C) from the drive pulley (D).

5. Using a 3/8” wrench and 5/32” allen wrench, remove the

nuts from the #10 puck retaining bolts (see fi gure17-11).

6. Remove the brake puck.

7. Remove the bolts from the puck.

Note: The puck ends are symmetrical and can be interchanged

to use a new braking surface unless both ends are already worn

(Figure 4). When both ends have been used replace the puck with

a new one.

8. Inspect the nylon brake arm spacer (Item 44).

9. Replace the spacer if it shows signs of wear.

10. Reassemble all parts in the same orientation as when

removed.

Note: Before installing fasteners, inspect them for wear and

replace as necessary.

11. Check the operation of the clutch and brake mechanism.

The drive belt should be slack and the brake engaged (center

pulley will not turn easily by hand) when no pressure is exerted

on blade drive lever.

Note: When the blade drive lever is depressed, the brake puck

should not rub on the center pulley, the belt should be under

tension, and not rub on the belt fi nger (see fi gure 17-10).

13. Replace the belt cover and connect the spark plug wire.

Start the engine and check the clutch/brake operation under

power.

Note: When the blade clutch control lever is pressed down, the

blades should spin up to speed without belt slippage indicated

by a pronounced belt squealing sound. When the clutch control

lever is released, the blades should stop spinning in 5 seconds

or less.

MAINTENANCE continued

17

BRAKE PUCK REPLACEMENT

17.6

Page 14 of 20

Figure 17-9

Figure 17-10

Figure 17-11

A

B

D

C

Belt fi nger should not

rub on belt when

drive is engaged.