Benton Harbor Michigan 49022 Installation Instructions
Download Installation instructions of Benton Harbor Michigan 49022 Cooktop, Washer for Free or View it Online on All-Guides.com.
Brand: Benton Harbor
Type: Installation instructions for Benton Harbor Michigan 49022
Pages: 5
Download Benton Harbor Michigan 49022 Installation instructions
1
2
3
4
5
Parts supplied:
Part No. 3952817 Rev. B
© 2001 Whirlpool Corporation
Benton Harbor, Michigan 49022
Printed in U.S.A.
Installation Instructions
120-volt
60-Hz
Washer
level
utility
knife
adjustable wrench or
9/16" open-end
wrench
scissors
✔
✔
18.
CHECK ELECTRICAL
REQUIREMENTS. BE SURE YOU
HAVE CORRECT ELECTRICAL
SUPPLY AND RECOMMENDED
GROUND METHOD.
Congratulations!
You have successfully installed
your new washer. To get the
most efficient use from your
new washer, read your Use and
Care Guide.
Keep Installation Instructions
and Guide.
19. Check that all parts are
now installed. If there is an extra
part, go back through steps to see
which step was skipped.
21. Check that you have all
of your tools. Check that the yellow
shipping strap was removed from the
back of the washer and used to
secure the drain hose.
G
Completing
Installation:
H
Need
Assistance?
20. Turn on water faucets
and check for leaks. Tighten
couplings if there is leaking. DO
NOT OVERTIGHTEN; this could
cause damage to couplings.
23.Read the Use and Care
Guide. Start the washer and allow it
to complete the regular cycle.
22. Plug power supply cord
into grounded outlet.
Call your dealer or local authorized
service company.
When you call, you will need the
washer model number and serial
number. Both numbers are on the
model/serial rating plate located
under the washer lid and on the top
of the washer.
(Step 13)
(Step 7)
(Step 6)
(Step 4)
Part No. 3952817 Rev. B
IMPORTANT:
Read and save these
instructions.
IMPORTANT:
Installer: Leave Installation Instructions with the homeowner.
Homeowner: Keep Installation Instructions for future reference.
Save Installation Instructions for local electrical inspector’s use.
yellow clamp
2 front leveling legs
with nuts
literature package
(inside washer)
Tools needed:
✔
pliers
2 inlet hoses
1 drain
hose
4 flat water
hose washers
drain hose clamp
Open lid and remove parts from
inside washer. Check that all parts
were included.
You can be killed or seriously injured if
you don’t follow instructions.
DANGER
WARNING
Your safety and the safety of others are very important.
We have provided many important safety messages in this manual and on
your appliance. Always read and obey all safety messages.
All safety messages will tell you what the potential hazard is, tell you how to
reduce the chance of injury, and tell you what can happen if the instructions
are not followed.
You can be killed or seriously injured if
you don’t immediately
follow instructions.
This is the safety alert symbol.
This symbol alerts you to potential hazards that can kill or hurt you
and others.
All safety messages will follow the safety alert symbol and either the word
“DANGER” or “WARNING”. These words mean: