• Home
• Brands
• Lennox Hearth Products Manuals
• Lennox Hearth Products SV4.5CTS Series
• Lennox Hearth Products SV4.5CTS Series Installation Manual

Lennox Hearth Products SV4.5CTS Series Installation Manual

Download Installation manual of Lennox Hearth Products SV4.5CTS Series Indoor Fireplace for Free or View it Online on All-Guides.com.

1

2

3

4

1

NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE.

HEARTH PRODUCTS

KITS AND ACCESSORIES

INSTALLATION INSTRUCTIONS FOR BLACK - SV4.5CTS-B (CAT. NO. H4716) & SV8CTS-B (CAT. NO. H6179)

AND TERRA COTTA - SV4.5CTS-TC (CAT. NO. H4717) & SV8CTS-TC (CAT. NO. H6180) TERMINATIONS

DIRECT VENT

CHASE TOP SQUARE

VERTICAL TERMINATIONS

750,207M

REV. A 07/2007

GENERAL INFORMATION

The SV4.5CTS and SV8CTS series terminations are designed to be

installed on top of locally fabricated chimney enclosure, referred to

herein as a chase. The terminations are designed to be used with tested

and listed Direct Vent pipe systems and manufactured appliances listed

for use with this product. The SV4.5CTS and SV8CTS terminations are

additionally designed and painted to be suitable for use by itself without

surround, providing a beautiful top to a standard chase.

WARNINGS

This termination is intended to be installed in accordance with the

installation guidelines of the pipe system and appliance it is joined to.

Failure to install this product within those guidelines as well as these

installation instructions can result in damage of property, bodily injury,

or death. The installation must conform with local codes or, with the

national fuel gas code, or ANSI Z223.1.

It is highly recommended that this product be installed by a qualified

technician. It is highly recommended that the technician be NFI certified

for gas appliance installations.

APPROVALS AND LISTINGS

The SV4.5CTS and SV8CTS series terminations are tested as a integral

component of the Direct Vent pipe system and may be used with any

manufactured fireplace listed for use with these components. These

terminations are listed for this application by Omni-Test Laboratories.

FOR YOUR SAFETY

When working on ladders, roofs, scaffolding, or any high surface, take

precautions to protect against accidents. Properly secure ladders, wear

safety harnesses and verify all operations are done to OSHA standards.

Also be aware of and avoid any and all electrical wires in or near your

working area.

When working with and around sheet metal, be aware of material edges.

Always wear gloves, safety glass and any other needed protective gear

when working with sheet metal.

Take appropriate precautions when operating power equipment.

KIT CONTENTS

1 - Termination

1 - Bag with fifteen (15) stainless steel screws

1 - Instruction Sheet

SV4.5CTS

Or SV8CTS

Termination

Chase Flashing

(Field Fabricated)

Pipe

Section