Dell 3130cn Service Manual
Download Service manual of Dell 3130cn - Color Laser Printer Label Maker, Printer for Free or View it Online on All-Guides.com.
Brand: Dell
Category: Label Maker , Printer
Type: Service manual for Dell 3130cn - Color Laser Printer
Pages: 854
1 - 188
Chapter 1 Troubleshooting
Version 3 2008.05.30
FIP1.12 007-340-03 Restart Printer
Step
Check Yes No
Possible causative parts:
FEEDER ASSY (PL3.2.1)
PWBA MCU (PL9.1.20)
HARN ASSY R SIDE (PL10.1.15)
DRIVE ASSY PH (PL8.1.7)
1
Checking the detail error code.
A detailed error code is displayed by pushing L key, K key
and 3 key simultaneously.
Is "Code:03" displayed on the LCD?
Go to step 2.
"00":Go to FIP1.9.
"01":Go to
FIP1.10.
"04":Go to
FIP1.13.
2
Checking the ROLL REGI RUBBER for rotation
Does the ROLL REGI RUBBER rotate smoothly?
Check the rotation of the ROLL REGI RUBBER with a fin-
ger.
Go to step 3.
Replace the
FEEDER ASSY.
3
Checking the connectors for connection
Check the connections between the PWBA MCU and
DRIVE ASSY PH.
Are P/J25 and P/J251 connected surely?
Go to step 4.
Reconnect the
connector(s)
P/J25 and/or
P/J251 surely,
then go to step 4.
4
Checking the PH Motor for rotation
Does the PH Motor function normally?
Checked by [Digital Output] - [DO-a(Control Panel)/PH
MOTOR ON(PC)] in diagnosis. During the test, close the
Front Cover.
Replace the
PWBA MCU.
(Refer to Removal
30/Replacement
14)
Go to step 5.
5
Checking the DRIVE ASSY PH for installation
Is the DRIVE ASSY PH installed correctly?
Go to step 6.
Reseat the
DRIVE ASSY PH,
then go to step 6.
6 Does the error still occur when the power is turned ON? Go to step 7. End of work
7
Checking the connectors of the DRIVE ASSY PH for con-
nection Check the connections between the PWBA MCU
and DRIVE ASSY PH.
Are P/J25 and P/J251 connected surely?
Go to step 8.
Reconnect the
connector(s)
P/J25 and/or
P/J251 surely.
8
Checking the HARN ASSY R SIDE for continuity Discon-
nect P/J25 from the PWBA MCU.
Disconnect P/J251 from the DRIVE ASSY PH.
Is each cable of P/J25 <=> P/J251 continuous?
Go to step 9.
Replace the
HARN ASSY R
SIDE.
9
Checking the power to DRIVE ASSY PH Disconnect the
connector of P/J25 on the PWBA MCU.
Are the voltages across ground <=> J25-1pin/J25-2pin on
the PWBA MCU, about +24 VDC when the interlock switch
(HARN ASSY INTERLOCK) is pushed?
Replace the
DRIVE ASSY PH.
(Refer to Removal
17/Replacement
27)
Replace the
PWBA MCU.
(Refer to Removal
30/Replacement
14)