Dell 3130cn Service Manual
Download Service manual of Dell 3130cn - Color Laser Printer Label Maker, Printer for Free or View it Online on All-Guides.com.
Brand: Dell
Category: Label Maker , Printer
Type: Service manual for Dell 3130cn - Color Laser Printer
Pages: 854
1 - 246
Chapter 1 Troubleshooting
Version 1 2008.02.15
FIP1.46 Error Y Cart 093-919
Step
Check Yes No
Possible causative parts:
CARTRIDGE ASSY (Y) (PL5.1.21)
DISPENSER ASSY (PL5.1.12)
HARN ASSY LV TOP (PL10.1.16)
PWBA MCU (PL9.1.20)
1
Checking the Toner Tape for staying
Has the Toner Tape been pulled out?
Go to step 2.
Pull the Toner
Tape out, then go
to step 2.
2 Does the error still occur when the power is turned ON? Go to step 3. End of work
3
Checking after replacing the CARTRIDGE ASSY (Y)
Replace the CARTRIDGE ASSY (Y).
Does the error still occur when the power is turned ON?
Go to step 4. End of work
4
Checking the Dispenser Motor for rotation
Does the Dispense Motor function normally?
Checked by [Digital Output] - [DO-21(Control Panel)/
TONER MOTOR Y ON(PC)] in diagnosis. During the test,
close the interlock switch (HARN ASSY INTERLOCK).
Check the gear of
the Auger is not
damaged. If the
gear is damaged,
replace the DIS-
PENSER ASSY
(Y). (Refer to
Removal 24/
Replacement 20)
Replace the
PWBA MCU.
(Refer to Removal
30/Replacement
14)
Go to step 5.
5
Checking the connector for connection
Check the connectors between the PWBA MCU and DIS-
PENSER ASSY.
Are P/J18 and P/J181 connected surely?
Go to step 6.
Reconnect the
connector(s)
P/J18 and/or
P/J181 surly,
then go to step 6.
6 Does the error still occur when the power is turned ON? Go to step 7. End of work
7
Checking the HARN ASSY LV TOP for continuity
Disconnect P/J18 from the PWBA MCU.
Disconnect P/J181 from the DISPENSER ASSY.
Is each cable of P/J18 <=> P/J181 continuous?
Go to step 8.
Replace the
HARN ASSY LV
TOP.
8
Checking the power to DISPENSER ASSY
Disconnect P/J18 on the PWBA MCU.
Are the voltages across ground <= >J18-A1pin/A2pin on
PWBA MCU, about +24 VDC when the interlock switch
(HARN ASSY INTERLOCK) is pushed.
Replace the DIS-
PENSER ASSY.
(Refer to Removal
24/Replacement
20)
Replace the
PWBA MCU.
(Refer to Removal
30/Replacement
14)