Frigidaire LRA127CT110 Use & Care Manual

Download Use & care manual of Frigidaire LRA087AT710 Air Conditioner for Free or View it Online on All-Guides.com. This version of Frigidaire LRA087AT710 Manual compatible with such list of devices, as: LRA087AT710, LRA127CT11, LRA127CT110, LRA127CT14, LRA127CT15

Frigidaire LRA087AT710 Use & care manual - Page 1
1
Frigidaire LRA087AT710 Use & care manual - Page 2
2
Frigidaire LRA087AT710 Use & care manual - Page 3
3
Frigidaire LRA087AT710 Use & care manual - Page 4
4
Frigidaire LRA087AT710 Use & care manual - Page 5
5
Frigidaire LRA087AT710 Use & care manual - Page 6
6
Frigidaire LRA087AT710 Use & care manual - Page 7
7
Frigidaire LRA087AT710 Use & care manual - Page 8
8
Frigidaire LRA087AT710 Use & care manual - Page 9
9
Frigidaire LRA087AT710 Use & care manual - Page 10
10
Frigidaire LRA087AT710 Use & care manual - Page 11
11
Frigidaire LRA087AT710 Use & care manual - Page 12
12
Beforecallingforservice,reviewthislist.It maysaveyoutimeandexpense.Thislistincludescommonoccurrencesthatarenot
theresultofdefectiveworkmanshipormaterialsinthisappliance.
OCCURRENCE SOLUTION
Air conditioner will not operate. Wall plug disconnected, Push plug firmly into wall outlet,
Plug Current Device Tripped, Press the RESET button,
House fuse blown or circuit breaker tripped, Replace fuse with time delay type or reset circuit breaker,
Control is OFF. Turn Control ON and set to desired setting,
Airfrom unitdoes not feelcold
enough.
Room temperature below 60°F (16°C). Cooling may not occur until room temperature rises above
60°F (16°C).
Temperature sensing element touching cold coil, located behind air filter. Straighten away from coil.
Reset to a lower temperature.
Compressor shut-off by changing modes. Wait approximately 3 minutes and listen for compressor to
restart when set in the COOL mode.
Air conditioner cooling, but room
is too warm = ice forming
on cooling coil behind decorative
front
Outdoor temperature below 60 °F (16 °C). To defrost the coil, set FAN ONLY mode.
Air filter may be dirty. Clean filter. Refer to Care and Cleaning section. To defrost, set to FAN ONLY
mode.
Temperature is set too low for night-time cooling. To defrost the coil, set to FAN ONLY mode. Then,
set temperature to a higher setting.
Air conditioner cooling, but room
is too warm = NO ice forming on
cooling coil behind decorative
front,
Dirty air filter - air restricted. Clean air filter. Refer to Care and Cleaning section.
Temperature is set too high. Set temperature to a lower setting.
Air directional louvers positioned improperly. Position louvers for better air distribution.
Front of unit is blocked by drapes, blinds, furniture, etc. - restricts air distribution. Clear blockage in
front of unit.
Doors, windows, registers, etc. open - cool air escapes. Close doors, windows, registers, etc.
Unit recently turned on in hot room. Allow additional time to remove "stored heat" from walls, ceiling,
floor and furniture.
Airconditionerturnson and off
rapidly.
Dirty air filter - air restricted. Clean air filter.
Outside temperature extremely hot. Set FAN speed to a faster setting to bring air through cooling coils
more frequently.
Noise when unit is cooling.
Air movement sound. This is normal. If too loud, set to lower FAN setting.
Window vibration - poor installation. Refer to installation instructions or check with installer.
Water dripping INSIDE when Improper installation. Tilt air conditioner slightly to the outside to allow water drainage. Refer to
unit is cooling, installation instructions or check with installer.
Water dripping OUTSIDE when Unit removing large quantity of moisture from humid room. This is normal during excessively humid
unit is cooling, days.
Room too cold, Set temperature too low. Increase set temperature.
If These Solutions Fail, Call 1-866-208-3616 For Frigidaire Service,
02009 Electrolux Home Products,Inc. All rights reserved.
1 1