Dell Networking S6000 Installation Manual
Download Installation manual of Dell Networking S6000 System Network Hardware, Switch for Free or View it Online on All-Guides.com.
Brand: Dell
Category: Network Hardware , Switch
Type: Installation manual for Dell Networking S6000 System
Pages: 56
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
18 | Site Location and Preparation
www.dell.com | support.dell.com
Site Selection
Dell Network’s equipment is intended for installation in restricted access areas. A restricted access area is
one in which access can only be gained by service personnel through the use of a special tool, lock, key,
or other means of security and access is controlled by the authority responsible for the location.
Ensure that the area where the S6000 system is installed meets the following safety requirements:
• Near an adequate power source. Connect the system to the appropriate branch circuit protection as
defined by your local electrical codes.
• Environmental temperature between 32° to 113°F (0° to 45°C).
• Relative humidity that does not exceed 90% non-condensing.
• In a dry, clean, well-ventilated and temperature-controlled room, away from heat sources such as hot air
vents or direct sunlight.
• Away from sources of severe electromagnetic noise.
• Positioned in a rack or cabinet, or on a desktop with adequate space in the front, rear, and sides of the
S6000 for proper ventilation and access.
Cabinet Placement
Install the S6000 only in indoor cabinets designed for use in a controlled environment as described in
Site
Selection
. Do not install the S6000 in outside plant cabinets.
The cabinet must meet the following:
• Minimum cabinet size and airflow are according to the Electronic Industries Alliance (EIA) standard.
Rack Mount
When you prepare your equipment rack, ensure that the rack is earth ground. Ground the equipment rack
to the same ground point used by the power service in your area. The ground path must be permanent.
Ground
Use the S6000 in a CBN. Connect the grounding cables as described in
Chapter 4, Install the S6000
.
Fans and Airflow
The S6000 fans support two airflow options. Be sure to order the fans suitable to support your site’s
ventilation. Use a single type of airflow fan in your system. Do not mix reverse and normal airflows in a
single S6000 chassis.