Dell Networking S6000 Installation Manual
Download Installation manual of Dell Networking S6000 System Network Hardware, Switch for Free or View it Online on All-Guides.com.
Brand: Dell
Category: Network Hardware , Switch
Type: Installation manual for Dell Networking S6000 System
Pages: 56
36 | Power Supplies
www.dell.com | support.dell.com
Figure 5-2. DC Power Connector and Wiring Block
To connect a S6000 DC PSU to the site’s DC power source, follow these steps:
Removing Power Connector from an S6000 DC Power Supply
To remove the power connector from an S6000 DC PSU, squeeze together the levers on both sides of the
connector. Doing so disengages the power connector’s clamps. While continuing to squeeze, pull the
power connector from the DC PSU socket.
Step Task
1 Strip 1/2” of insulation from each of the power connector’s wires (red and black, See
Figure 5-2
).
2 Insert each of the power connector’s bare wire lengths into the wiring block (See
Figure 5-2
). Red into one hole
and black into the other hole.
3 Use a flat-blade screwdriver to tighten the screws, which secures the bare wires into the wiring block.
4 Secure the site’s DC power source wires to the other side of the wiring block.
WARNING: Make sure not to cross the wires—In the wiring block, red should align with red and
black should align with black (See
Figure 5-2
).
5 Insert the DC power connector into the power socket of the S6000 DC PSU. Make sure that you feel the connector
pins firmly seat and you hear the click of the power connector’s left and right levered clamps lock into place.
WARNING: Never try to force the power connector into or out of the DC PSU power socket.
Wiring Block
Power Connector
Screws