C–10 16023522 ©2004 Maytag Services
Conversion Instructions (Models AGR5712AD*, CG34800AD*,
CGR3725AD*, MGR5751AD*, MGR5752AD*, PGR5720LD*)
All ranges are equipped with fixed orifices and with a
convertible appliance pressure regulator. The unit model
number plate states which gas it is adjusted for at the
factory. To convert the unit to either Natural gas or LP
gas will require the replacement of the orifice hoods, and
the adjustment of the air shutters on the burners and
adjustment of the appliance pressure regulator converter
cap.
Inlet pressure to the appliance pressure regulator should
be as follows for checking the appliance pressure
regulator setting:
Minimum 5 11
Maximum 14 14
The unit appliance pressure regulator must be set to
match the type gas supply used. If converting from
natural gas to LP gas, the appliance pressure regulator
must be converted to regulate LP gas. If converting from
LP gas to natural gas, the appliance pressure regulator
must be converted to regulate natural gas.
To access the regulator from front of range, remove the
storage drawer or warming drawer.
Pull out to the first stop
position. Lift up front of drawer and pull to the second
position, grasp sides and lift up and out to remove drawer.
To convert the appliance pressure regulator from one gas
to another, remove plastic dust cover from cap nut on top
of appliance pressure regulator. Remove cap nut from
appliance pressure regulator (plastic dust cover comes off
with nut).
Remove plastic dust cover from cap nut
and reinstall on opposite side of cap nut.
Reinstall cap nut to appliance pressure regulator and
replace dust cover.
Be sure marking for the type of gas to which
appliance pressure regulator has just been converted is
visible in top of cap nut before replacing plastic dust
cover. (See figure 1.)
Fit the drawer rollers
onto the rails. Lift up drawer front and gently push in to
first stop position. Lift up and continue to slide drawer to
the closed position.
(03-04-00)
