TO BE REMOVED BY THE CUSTOMER AFTER INSTALLATION IS COMPLETE.
f
[] INSTALLATION CHECKOFF LIST
Doors
[] Handbs are secure and tight
[] Door seaUscompbteUy to cabinet on al sides
[] Doors are bveUacross the top
Levelng
[] Refrigerator is bveL side to side and tlted 1/4" (6mm) front to back
[] Toe gdle is property attached to refrigerator
[] Cabinet is setting sold on al corners
[]
[]
ice Maker
ElectricaJ Power
House power turned on
[] House water supply connected to refrigerator
[] Water & power couplings connected at door
[] No water leaks present at all connections - recheck in 24 hours
[] Ice Maker is turned ON,
[] Ice & Water Dispenser operates correctly
[] Front filter must be flush with filter housing (some models)
FinaJ Checks
[] Shipping material removed
[] Fresh Food and Freezer controls set
[] Crisper Humidity controls set
[] Registration Card sent in
1
HAND TRUCKING
* Lead refrigerator from side of cabinet
only,
o Do not run retaining straps over
handles,
* Do not over-tighten retaining straps,
* Never use refrigerator handles to
move the refrigerator,
Remove tape from doors only after
unit is in place,
f
iNSTALLATiON CLEARANCES
Allow the following clearances for ease of installation,
proper air circulation, and plumbing and electrical
connections:
* Sides &Top .......... 3/8"
* Back ....................... 1"
NOTE: if you are installing your refrigerator beside a wall,
leave 1/2" minimum between hinges and wal to alow for
the door to swing open.
Ensureicemaker isturned ON.Check to see that the ice & Water
Dispenser is operating correctly. (See Automatic ice & Water
Dispenser Features in Use & Care Mat_ua!.)
k
SHIPPING MATERIAL
1 PIECE OF FOAM
OR CARDBOARD
2 WiRE TIES
(A/ wire baskets
will have 2 wire
ties)
-T.......
-- 1 PIECE OF TAPE
I PIECE OF -rAPE OR
2 BLUE SHIPPING CLIPS
I PIECE OF TAPE
SHELF SPACER WtTH TOE GRILLE
-- I PIECE OF TAPE
3 PIECES OF TAPE
I PIECE OF TAPE
\ Remove Shipping material (Features may vary per model.) ..
Tools You Will Need:
Phllps r" head
: 2?:
............ warERSup
Connect water supply - check for water leaks, Turn icemaker OFF
if water supply is not connected immediateJyo Connecting to a
reverse osmosis system is not recommended.
J
f
LEVELING AND ADJUSTING
All four corners of refrigerator must rest firmly on a sold
floor, Your refrigerator has adjustable rollers to help level it
and to adjust the doors,
To level cabinet or change door height:
1, Remove toe grille,
2, Use a screwdriver, 3/8"wrench, or nutdriver to adjust the
rolers, To raise cabinet or door, turn screw clockwise,To
lower cabinet or door, turn screw counterclockwise,
_:) i ....... _ ..............................
If you need to remove the doors to get your refrigerator in the house, please See
Door Removs/Instructions in your Use & Care Manual,
CONTROLS
x' See"Norma_ Operating Sights & Sounds" in the Use & Care
Manual so you understand the sounds you may hear once
your refrigerator is running,
_/ Please read entire Use & Care ManuaMo become aware of
important safety instructions and to become familiar with your
new refrigerator,
x' Send in Registration card to register your refrigerator,
_] Congratulations! You are ready to enjoy your new refrigerator,
IF YOU ARE DISSATISFIED WITH THE INSTALLATION OF YOUR REFRIGERATOR, PLEASE CALL THE STORE YOU PURCHASED IT FROM. P/N:241582500
