NEC Conference Max Plus User Manual
Download Operation & user’s manual of NEC Conference Max Plus Conference Phone, Conference System for Free or View it Online on All-Guides.com.
Brand: NEC
Category: Conference Phone , Conference System
Type: Operation & user’s manual for NEC Conference Max Plus
Pages: 2
1
2
To Connect and Charge Batteries
1. Slide the cover off the battery compartment on the bottom of the pod.
2. Connect the battery pack plug into the port in the compartment and insert the
battery pack. Slide the cover back into place.
3. Connect the power supply/charger to the conferencing pod and plug it into an
electrical outlet. Charge batteries for 15 hours prior to first use.
To Connect Base Unit
1. Connect one end of the telephone
cable into the phone jack on the
back of the base unit and the other
end into a wall jack.
2. Connect a recording device to the
2.5mm audio jack (if desired).
3. Connect the power cord to the
base unit and plug it into an
electrical outlet. The base unit
may be located up to 150 feet
from the conferencing pod.
CONFERENCE PHONE SETUP
Getting Started Guide
Figure 1. Connecting and charging the battery
Paging button
In Use and
Power LEDs
Figure 2. Connecting the base unit
To Access the Programming Menus
Press and hold until appears on the LCD screen.Then press the key that
corresponds with the desired menu option and follow the instructions below.
PROGRAMMING OPTIONS
NEC Conference Max Plus
Audio Conferencing
*Press and hold the "1" key to enter a hyphen or the "*" key to enter a space in the number. If a number has already
been programmed, use CLEAR to delete the old number before entering the new number.
Ringer Melody
1
Dialing Mode
2
Flash Duration
3
Local Number*
4
Conference*
5
Service*
6
Key ProgrammingMenu Option
1-5 to select a new melody. Press to save selection.
Press . The current melody selection will flash. Press
1 for tone, 2 for pulse. Press to save selection.
Press . The current dialing selection will flash. Press
Press . Enter the phone number that you want the
Conference key to dial. Press to save the number.
select duration. 1 = 600ms, 2 = 300ms, 3 = 150ms, 4 = 100ms,
Press . The current duration will flash. Press 1-5 to
5 = 80ms. Press to save selection.
appear on the LCD screen when the phone is in standby.
Press . Enter the phone number that you want to
Press to save selection.
Press . Enter the phone number that you want the
0 key to dial. Press to save the number.
Press CLEAR once to return to the previous menu level or hold to exit
Programming mode without saving changes.
!
CAUTION: Read the Safety Information in the instruction manual.
© 2005 . All rights reserved. No part of this document may be reproduced in any form or by any means without written
permission from NEC. NEC reserves specific privileges. Information in this document is subject to change without notice.
NEC Conference MaxPlus is protected by U.S. Patent No. D499,392 Part No. 800-157-201 (Rev. BETA)