Generalmusic RP220 Service Manual

Download Service manual of Generalmusic RP220 Musical Instrument for Free or View it Online on All-Guides.com.

Generalmusic RP220 Service manual - Page 1
1
Generalmusic RP220 Service manual - Page 2
2
Generalmusic RP220 Service manual - Page 3
3
Generalmusic RP220 Service manual - Page 4
4
Generalmusic RP220 Service manual - Page 5
5
Generalmusic RP220 Service manual - Page 6
6
Generalmusic RP220 Service manual - Page 7
7
Generalmusic RP220 Service manual - Page 8
8
Generalmusic RP220 Service manual - Page 9
9
Generalmusic RP220 Service manual - Page 10
10
Generalmusic RP220 Service manual - Page 11
11
Generalmusic RP220 Service manual - Page 12
12
Generalmusic RP220 Service manual - Page 13
13
Generalmusic RP220 Service manual - Page 14
14
1
Index
Soldering point.
Male connector.
Female connector.
M/F faston connector.
Test point.
Supply voltage. Logic supply ground.
Analog supply ground.
Chassis ground.
Earth ground.
Flag joined with one or more flags
GENERALMUSIC S.p.A. Sales Division: 47842 S.Giovanni in Marignano (RN) ITALY - Via delle Rose, 12
Phone +39(0)541/959511 - Fax +39(0)541/957404 - GENERALMUSIC on the NET: http://www.generalmusic.com
Opening & Keyboard Disassembling Instructions2
Autotest Procedure
Autotest Procedure, Frequently Asked Questions
3
Block Diagram5
6
Keyboard Interface and L/R Contact Boards7
Power Amplifier & Supply, Outputs and Phones Boards
8
Cpu & Sound Generator Board Layout & Timing Table9
Spare Part List
10
12
Controls Panel and Display Boards
Cpu & Sound Generator Board
4
SERVICE MANUAL
CODE: 270247
Warnings
with the same signal name inscribed.
Address
ATTENTION Observe
precautions when handling electrostatic sensitive devices.
Notice
Service must be carried out by qualified personnel only. Any tampering carried out by unqualified personnel during the guarantee period
will forfeit the right to guarantee.
For a correct operation of the instrument, after having switched off, be careful to wait at least 3 seconds before switching on again.
To improve the device's specifications, the schematic diagrams may be subject to change without prior notice.
All components marked by this symbol have special safety characteristics, when replacing any of these components use only
manufacturer's specified parts.
The (µ) micro symbol of capacitance value is substituted by U.
The (
) omega symbol of resistance value is substituted by E.
The electrolytic capacitors are 25Vdc rated voltage unless otherwise specified.
All resistors are 1/8W unless otherwise specified.
All switches shown in the "OFF" position. All DC voltages measured to ground with a voltmeter 20KOhm/V.