Acroprint 200 General Service Instructions
Download Installation use and care manual of Acroprint 200 Clock, Timer for Free or View it Online on All-Guides.com.
1
2
3
4
I2
I
2
3
4
5
6
7
8
9
I0
II
C
R
O
PR
I
T
N
RALEIGH, N.C. USA
General Service Instructions
Acroprint Model 200 Clip-O-Matic Recorder
To Remove Case Cover
1) Turn key one quarter turn clockwise.
2) Lift case cover up then forward.
3) Reverse procedure to replace cover.
To Set Time and/or Date
NOTE: Unless your recorder is equipped with
continental (0-23) hours, all PM hours on the time
card will be printed underscored (Ex.:
1:00). To
change the time and/or date follow these steps:
1) Unplug recorder and remove Case Cover.
2) To Set Time
A) Pull and release Yellow Lever to set the correct
time (see figure 1). If yellow lever does not
work, plug in recorder and wait for minute hand
to advance, then unplug recorder and try lever
again. DO NOT MOVE CLOCK HANDS TO
SET THE TIME.
3) To Set Day/Date
A) Make sure current time setting is between
midnight and noon (see note above).
B) Push and release Blue Lever (see figure 1) to
set correct day/date.
C) Plug in recorder and punch card to verify correct
setting. Repeat steps A-C if reading is incorrect.
4) To Set Month (if so equipped)
A) Turn Month Knob (see figure 1) counter-
clockwise to select correct month.
B) Plug in recorder and punch card to verify correct
setting. Repeat steps A-B if reading is incorrect.
5) To Set Year (if so equipped)
A) Insert point of pen into spoke on side of year
wheel and rotate counter-clockwise.
B) Plug in recorder and punch card to verify correct
setting. Repeat steps A-B if reading is incorrect.
Figure 1 (front view with cover removed)
IMPORTANT NOTES
1) The date setting (if so equipped) MUST
be manually reset to the first of the
month each month, following any month
with less than 31 days.
2) The month and year settings (if so
equipped) MUST be manually reset
every month/year.
3) To reset you recorder after a power
failure follow the steps 1-5.
4) HINT: If clock is set slightly ahead of actual
time, you may unplug it until it matches the
correct time.
Yellow Lever (time)
Blue Lever (day/date)
Month Knob (turn counter-clockwise)