American Standard Heritage Pedestal Sink 0191.134 Installation Instructions

Download Specification sheet of American Standard Heritage Pedestal Sink 0191.134 Indoor Furnishing for Free or View it Online on All-Guides.com.

American Standard Heritage Pedestal Sink 0191.134 Specification sheet - Page 1
1
J1
© 2008 AS America Inc.
HERITAGE™
PEDESTAL SINK
VITREOUS CHINA
HERITAGE™ PEDESTAL SINK
Classic design with large, spacious deck space
Made from vitreous china
Rear overow
Design-matched to Heritage toilets
Supplied with mounting kit
0191.134 Faucet holes on 8" (203mm) centers
Nominal Dimensions:
762 x 514 x 864mm
(30" x 20-1/4" x 34")
Separate Components:
0191.643 Pedestal top-8" (203mm) centers
734700-400 Pedestal only
Bowl sizes:
454mm (17-7/8") wide
295mm (11-5/8") front to back
165mm (6-1/2") deep
Compliance Certications -
Meets or Exceeds the Following Specications:
• ASME A112.19.2M for Vitreous China Fixtures
To Be Specied:
Color: White Bone Linen
Faucet*:
Faucet Finish:
❏ Supplies:
1-1/4" Trap:
* See faucet section for additional models available
NOTES:
*
DIMENSIONS SHOWN FOR LOCATION OF SUPPLIES AND “P" TRAP ARE
SUGGESTED.
▼PEDESTAL ANCHORING SCREWS NOT INCLUDED.
SUITABLE FOR REINFORCEMENT ONLY. ACTUAL DIMENSIONS MUST
BE TAKEN FROM FIXTURE.
FITTINGS NOT INCLUDED AND MUST BE ORDERED SEPARATELY.
PROVIDE SUITABLE REINFORCEMENT FOR ALL WALL SUPPORTS.
INSTALLATION INSTRUCTIONS SUPPLIED WITH LAVATORY.
IMPORTANT: Dimensions of xtures are nominal and may vary within the
range of tolerances established by ANSI Standard A112.19.2.
These measurements are subject to change or cancellation. No responsibility
is assumed for use of superseded or voided pages.
DRAIN
CHASE
OPEN
TO
FLOOR
*
*
864mm
(34)
203mm
(8)
102mm
(4)
102mm
(4)
511mm
(20-1/8)
572mm
(22-1/2)
178mm
(7)
514mm
(20-1/4)
762mm
(30)
203mm
(8)
73mm
(2-7/8)
191mm
(7-1/2)
(3) 35mm (1-3/8)
DIA. HOLES
SLOTS FOR
ANCHOR SCREWS
SUPPLIES AS
REQUIRED
1-1/4 O.D.
WASTE OUTLET
1-1/4 O.D.
TAILPIECE
FINISHED
WALL
FINISHED
FLOOR
743mm
(29-1/4)
(2) 11mm (7/16)
ANCHOR BOLT HOLES
n
248mm
(9-3/4)
Revised 2/08