Miles Industries PORTRAIT Installation Instructions Manual

Download Installation instructions manual of Miles Industries PORTRAIT Indoor Fireplace for Free or View it Online on All-Guides.com.

Miles Industries PORTRAIT Installation instructions manual - Page 1
1
Miles Industries PORTRAIT Installation instructions manual - Page 2
2
Miles Industries PORTRAIT Installation instructions manual - Page 3
3
Miles Industries PORTRAIT Installation instructions manual - Page 4
4
Miles Industries PORTRAIT Installation instructions manual - Page 5
5
Miles Industries PORTRAIT Installation instructions manual - Page 6
6
Miles Industries PORTRAIT Installation instructions manual - Page 7
7
Miles Industries PORTRAIT Installation instructions manual - Page 8
8
Miles Industries PORTRAIT Installation instructions manual - Page 9
9
Miles Industries PORTRAIT Installation instructions manual - Page 10
10
Miles Industries PORTRAIT Installation instructions manual - Page 11
11
Miles Industries PORTRAIT Installation instructions manual - Page 12
12
Miles Industries PORTRAIT Installation instructions manual - Page 13
13
Miles Industries PORTRAIT Installation instructions manual - Page 14
14
Miles Industries PORTRAIT Installation instructions manual - Page 15
15
Miles Industries PORTRAIT Installation instructions manual - Page 16
16
Miles Industries PORTRAIT Installation instructions manual - Page 17
17
Miles Industries PORTRAIT Installation instructions manual - Page 18
18
Miles Industries PORTRAIT Installation instructions manual - Page 19
19
Miles Industries PORTRAIT Installation instructions manual - Page 20
20
4002418-07
569 Ledge Front
INSTALLATION INSTRUCTIONS
CSA approved for use with Valor Models 530I Heaters ONLY
Notes: This kit must be installed or serviced by a quali ed
installer, service agency or gas supplier. These instructions are to
be used in conjunction with the main installation instructions
for Valor heater model 530I.
The installation of this kit affects the framing and method of
installing the 530 heater.
Installation Sequence
1. Frame the cavity.
2. Install the heater with stud brackets, stand-offs, insulation, wall switch
kit, and cement board.
3. Gas t and vent heater.
4. Drywall only (no tile, etc.).
5. Assemble and install the mounting frame.
6. Install nishing material (tile, etc.). Finish around or under 570 Finishing
Plate if using it.
7. Install the trim panel tted with the barrier screen.
INSTALLER
Leave this manual
with the appliance.
CONSUMER
Retain this manual
for future reference.
HOT GLASS WILL
CAUSE BURNS.
DO NOT TOUCH GLASS
UNTIL COOLED.
NEVER ALLOW CHILDREN
TO TOUCH GLASS.
WARNING
!
A barrier designed to reduce the risk of burns from the hot viewing
glass is provided with this appliance and shall be installed
for the protection of children and other at-risk individuals.
PORTRAIT
© Copyright Miles Industries Ltd., 2013.