Compaq StorageWorks RAID Array 4100 Configuration
Download Configuration of Compaq Armada 4100 Laptop for Free or View it Online on All-Guides.com.
1
2
To install the Compaq StorageWorks RAID Array 4100 redundant
components:
1. Shut down the server and the storage system.
2. To install the redundant RA4000 Controller, complete
these steps:
A. Remove the blank panel located at the rear of the
RA4100.
B. Insert the redundant RA4000 Controller into the
tracks in the rear panel opening.
C. Push the board in as far as it will go and close both
latches against the rear panel. The levers on each latch
should catch behind the metal lip, drawing the board
into position and securing it into place.
3. Install the second Compaq Fibre Channel Storage Hub in the
rack or other location. Refer to the documentation supplied
with this device for details.
4. Install the second Compaq Fibre Channel Host Adapter
in a convenient slot in the server. Refer to the Compaq
StorageWorks Fibre Channel Host Adapter Installation Guide.
5. Install the GigaBit Interface Converter (GBIC) modules in
the receptacles provided on the Fibre Channel host
adapter, RA4000 Controllers, and Fibre Channel Hubs.
Simplified Instructions for Installing the Redundant Components
©1999 Compaq Computer Corporation.
All rights reserved. Printed in the U.S.A.
Compaq, ProLiant, ProSignia, and ROMpaq
registered United States Patent and Trademark Office.
First Edition (September 1999)
Part Number 146298-001
340426- 001
Ref # Identifier
RA4000 Controller
RA4100
GigaBit Interface Converters
Fibre Channel Host Adapters
Fibre Channel Storage Hub 7 or 12
Server
StorageWorks RAID Array 4100
6. Connect the Fibre Channel host adapter, the RA4000
Controller, and the Storage Hub, using the appropriate
length of multi-mode Fibre Channel cable. Two GBIC
modules are required for each Fibre channel cable installed.
7. Apply power to the equipment in the following order:
A. Storage Hubs (accomplished by plugging in A/C
power cord)
B. RA4100
C. Server
Features
The following features apply to the Compaq StorageWorks RAID
Array 4100:
Models Rack-Mountable
Maximum Number of Drives Twelve, 1-inch
Hard Drive Interface Wide-Ultra SCSI-3
Fast-Wide SCSI-2
Supported Drives Compaq Hot Plug Ultra2 Disk
Drives
SCSI ID Select Automatic
Hubs Storage Hub 7
Storage Hub 12
GBICs GBIC-SW
GBIC-LW
Fibre Channel Cable Types 50-micron multimode
62.5-micron multimode
9-micron single mode
Option Redundant Power
Supply
Hot-Pluggable Components Hard Drives
Fan Assembly
Redundant Power Supplies
Fibre Channel Host Adapters
RA4000 Controllers
Fibre Channel Cable
Status Indicators Storage System Front Panel
Fan Assembly
RA4000 Controller
StorageWorks RAID Array 4100 Features
146298- 001
6
2
3
4
5
3
1
3
2
1
Better Answers
Configuration
Compaq
StorageWorks
RAID Array
4100