• Home
• Brands
• Nordyne Manuals
• Nordyne R-410A
• Nordyne R410-A User's Information And Installation Instructions Manual

Nordyne R410-A User's Information And Installation Instructions Manual

Download User's information and installation instructions manual of Nordyne R-410A Air Conditioner, Heat Pump for Free or View it Online on All-Guides.com.

1

2

3

4

5

6

7

8

9

10

11

12

12 SEER R410-A High Efficiency Split System

These units have been designed and tested for

capacity and efficiency in accordance with A.R.I.

Standards. Split System Air Conditioning units

are designed for use with a wide variety of fossil

fuel furnaces, electric furnaces, air handlers,

and evaporator coil combinations.

Outdoor Air Conditioner

User’s Information and Installation Instructions

These instructions are primarily intended to

assist qualified individuals experienced in the

proper installation of heating and/or air

conditioning appliances. Some local codes

require licensed installation/service personnel

for this type of equipment. Read all instructions

carefully before starting the installation.

USER’S INFORMATION

IMPORTANT

Read this owner information to become familiar

with the capabilities and use of your appliance.

Keep this with literature on other appliances

where you have easy access to it in the future.

If a problem occurs, check the instructions and

follow recommendations given. If these

suggestions don’t eliminate your problem, call

your servicing contractor .

OPERATING INSTRUCTIONS

To Operate Your Air Conditioner for

Cooling —

1. Set the thermostat system switch to COOL

or AUTO and the thermostat fan switch to

AUTO. (See Figure 1)

2. Set the thermostat temperature to the

desired temperature level by pressing the

WARMER or COOLER button. Please

refer to the separate detailed thermostat

user's manual for complete instructions

regarding thermostat programming. The

outdoor unit and indoor blower will both

cycle on and off to maintain the indoor

temperature at the desired cooling level.

To Operate Your Furnace for

Heating —

1. Set the thermostat system switch to HEAT

or AUTO and the thermostat fan switch to

AUTO. (See Figure 1)

2. Set the thermostat temperature to the

desired temperature level by pressing the

WARMER or COOLER button. Please

refer to the separate detailed user's manual

for complete thermostat programming

instructions. The furnace and indoor blower

will cycle on and off to maintain the indoor

temperature at the desired heating level.

To Shut Off Your Air Conditioner —

Set the thermostat system switch to OFF and the

thermostat fan switch to AUTO. (See Figure 1)

The system will not operate, regardless of the

thermostat temperature setting.

To Operate the Indoor Blower

Continuously —

Set the thermostat fan switch to ON (See

Figure 1)

The indoor blower will start immediately, and

will run continually until the fan switch is reset to

AUTO.

Figure 1. Typical Thermostat

SYSTEM SWITCH

FAN SWITCH

TEMPERATURE SCALES

TEMPERATURE

SELECTOR