HP LaserJet M3027 Getting Started Manual
Download Getting started manual of HP M3027 All in One Printer, Cooktop for Free or View it Online on All-Guides.com.
11
Note: If the address location displays a series of zeros, make sure that you are connected to the network and reprint
the configuration page.
23
Configure the IP address. On the control panel, scroll to and touch Administration. Scroll to and touch Initial Setup, and
then Networking and I/O. Touch Embedded Jetdirect, TCP/IP, and IPV4 SETTINGS. Touch CONFIG METHOD, make sure it is
set to MANUAL, and touch Save. Touch MANUAL SETTINGS, and then enter the IP ADDRESS, SUBNET MASK, and DEFAULT
GATEWAY.
You are done with the setup of the control panel. Now move to your computer and proceed with: Install the software.
Remarque : Si l'adresse affiche une série de zéros, assurez-vous que vous avez connecté le périphérique au réseau
et imprimez à nouveau la page de configuration.
Configuration de l'adresse IP. Sur le panneau de commande, faites défiler l’écran et appuyez sur Administration. Recherchez
et appuyez sur Configuration initiale, puis sur Réseau et E/S. Appuyez sur Jetdirect intégré, TC P/IP, et PARAMETRES IPV4.
Appuyez sur METHODE DE CONFIGURATION, assurez-vous que le paramètre MANUELLE est sélectionné, puis appuyez
sur Enregistrer. Appuyez sur PARAMETRES MANUELS, puis saisissez l'ADRESSE IP, le MASQUE DE SOUS-RESEAU et la
PASSERELLE PAR DEFAUT.
La configuration du panneau de commande est terminée. Passez sur votre ordinateur et effectuez l'étape suivante :
Installation du logiciel.
. :
Networking and () Initial Setup . () Administration .IP
CONFIG .(IPV4) IPV4 SETTINGSTCP/IP( Jetdirect) Embedded Jetdirect .(/) I/O
IP() MANUAL SETTINGS .() Save() MANUAL() METHOD
.() DEFAULT GATEWAY() SUBNET MASK ( IP) ADDRESS
. : .