Waterfall Audio Elora User Manual
Download Operation & user’s manual of Waterfall Audio Elora Speakers for Free or View it Online on All-Guides.com.
Brand: Waterfall Audio
Category: Speakers
Type: Operation & user’s manual for Waterfall Audio Elora
Pages: 2
1
2
• Set up of your A/V Processor
In the set up menu : choose to have all the speakers in "small" mode, even if you are combining Elora with some Victoria
or Iguasçu. If your processor allows for a choice of frequency roll off, please choose a frequency as close as possible to
120 Hz.
• Set Up of your Waterfall Subwoofer
On the Waterfall Subwoofer position the switch to "24-12-LFE" on the LFE position. Phase should be on 0°; adjust its
frequency roll off to the maximum (150Hz). Adjust the volume level to your taste.
Weither in Stereo or multichannel use, the subwoofer should be as close as possible to the front speakers. In order to
get the best result between the sub and the satellites, it might be useful to adjust the phase of subwoofer. A good phase
linking up will give a very dense and bodied sound restitution whereas a bad linking up of the phase will show as lacking
energy in the low-medium frequencies.
With the Elora range of speakers and its innovative technologies, it is now possible to experience a new dimension in
sound, unknown until now with such compact speakers. However a lot of the final result will depend on the quality of
the Processor set ups. Do not hesitate to call on your experienced and professional dealer to set up your installation
For all technical questions, we can be reached at the following e-mail address: [email protected]
Please ensure that 4mm diameter screws are used, and make sure that they are well in place inside the wall
before finally tighening the bracket to the wall.
Cabling of the speaker can now take place, then take away the protective foam and position the speaker on
the attached bracket. Slide the speaker down into the screw hole of the attached wall bracket.
Check for perfect and safe positionning .
Despite its compact size, Elora has a high power handling due to the use of the "Heatstream Technology".
A good quality amplifier with a power between 40 W – 200 W per channel should be used.
We strongly recommend that you combine the Elora with a Waterfall "High Force" Subwoofer which has been specifically
developped for our range of Speakers.
5) Acoustic set- upwithin your Audio Video system:
Please take time to read this manual carefully. It is recommended to be assisted by another person during the final cabling
phase and wall hanging.
1) Unpacking :
During the whole process of the wall hanging, please ensure that the lateral protective foams are in place to protect your
speaker.
2) Cabling of the speaker :
3) Wall hanging :
4) Fixing on its shelf stand :
1) remove the 2 screws at the bottom.
2) position the shelf stand in front of the 2 holes, re-insert
the screws and screw them tightly.
3) run the cable to the speaker (beware of polarity: + & -).
4) position the speaker on its stand on the desired location.
5) remove the packing foam from the extremities of the speaker.
During handling time, make sure to keep the
packing foam on the extremities of
the speaker (as in the box)
1) Bring the speakers close to the wall and
insert the 2 screws at the back of the Elora
in the 2 holes of the wall bracket.
slide the speaker down until it stops
2) Slide the speaker down until it stops
Speaker cable: beware of polarity: + & -
Please ensure that the wall
bracket is firmly fixed to the wall.
If the speaker is not wall hanged, the optional shelf stand is available from
your Waterfall dealer.
Your Elora center speaker should be at a recommended
20 to 80 cm height from the ground.
We thank you very much for choosing Waterfall Audio speakers. Our
deliberate design choice for aesthetics and high performance is constantly
guiding our research and development, leading us to major new innovations.
In order to take advantage of the exceptional qualities of our speakers, we
recommend you read this manual very carefully. For optimal performance
we highly recommend the use of a Waterfall High Force Subwoofer.
Important instructions to be read before use
• The speaker you have purchased incorporates one GLASS PANEL.
• Any Impact on the product could potentially damage the product.
• There is a potential risk of injury to persons if the product is not used as instructed.
• In the event the speakers break, DO NOT
attempt to pick up the pieces of glass of the speaker without first
protecting your hands and using appropriate tools in collecting the pieces of the speaker.
USE CAUTION WHEN UNPACKING, REPACKING, INSTALLING AND USING THE PRODUCT.
Warning :
GLASS. FRAGILE : HANDLE & USE WITH CARE.
FRAGILE
User’s Manual
All drivers are developed and manufactured by Atohm (France).
Unité de fabrication et bureaux : ZA Praderies, 83 570 Carcès - France - Tel : +33 (0)4 98 05 11 30 - Fax : +33 (0)4 98 05 11 31 - contact@waterfallaudio.com
www.waterfallaudio.com
www.waterfallaudio.com
Made in France
6) Warranty
See Waterfall Warranty Card
This document is to be included in any resale of the product.
"On wall" satellite speakers
Elora
We highly recommend the use of Waterfall Audio
Cable made up with a high quality oxygen free copper,
which you can purchase from your Waterfall dealer.
The back part of the speaker case has 2 grooves
through which the Waterfall cable can be inserted.
+
-
adjust level and lock