• Home
• Brands
• JVC Manuals
• JVC GR-SXM750
• JVC GR-SXM750 Instructions Manual

JVC GR-SXM750 Instructions Manual

Download Instructions manual of JVC GR-SXM750 Camcorder for Free or View it Online on All-Guides.com.

1

2

3

4

5

6

7

8

9

10

11

12

13

14

15

16

17

18

19

20

21

22

23

24

25

26

27

28

29

30

31

32

6

GETTING STARTED

Hook on.

Push in.

BATTERY RELEASE Switch

Battery pack

Power Switch

To DC IN

connector

To AC outlet

AC Adapter

CHARGING THE BATTERY PACK

1) Hook the end of the battery pack to the

camcorder and push the battery in until it locks

in place.

• If the battery pack is attached in the wrong

position, a malfunction may occur.

2) Set the Power Switch

@ to “OFF” while pressing

down the Lock Button

! located on the switch.

Connect the AC Adapter to the DC IN connector

9.

3) Plug the AC Adapter into an AC outlet. The

CHARGE lamp

) blinks to indicate charging

has started.

4) When the CHARGE lamp

) stops blinking but

stays lit, charging is finished. Unplug the AC

Adapter from the AC outlet. Disconnect the AC

Adapter from the camcorder.

To Detach The Battery Pack . . .

... slide BATTERY RELEASE

8 and pull out the

battery pack.

Battery pack

BN-V11U

BN-V12U (optional)

BN-V20U (optional)

BN-V400U (optional)

Charging time

approx. 1 hr. 40 min.

approx. 1 hr. 40 min.

approx. 2 hrs. 40 min.

approx. 5 hrs. 10 min.

Charging times are for a fully discharged battery pack.

USING THE BATTERY PACK

Perform step 1) of “CHARGING THE BATTERY

PACK”.

Approximate recording time (unit: min.)

( ):when the video light is on

Battery pack

BN-V11U

BN-V12U

(optional)

BN-V20U

(optional)

BN-V400U

(optional)

Viewfinder on

80

(45)

80

(45)

135

(75)

315

(165)

LCD monitor on

75

(40)

75

(40)

120

(70)

285

(180)

USING AC POWER

Connect the AC Adapter to the camcorder ( step

2) and 3) of “CHARGING THE BATTERY PACK”).

• The provided AC Adapter features automatic

voltage selection in the AC range from 110 V to

240 V.

ATTENTION

Before detaching the power source, make sure

that the camcorder’s power is turned off. Failure to

do so can result in a camcorder malfunction.

REFRESH:

Be sure to fully discharge a battery pack before

recharging otherwise the battery performance will

be reduced.

1) Perform steps 1) through 3) of “CHARGING

THE BATTERY PACK”.

2) Press REFRESH

q for over 2 seconds. The

POWER lamp

$ blinks to indicate discharging

has started.

3) When discharging is finished, charging

automatically starts and the CHARGE lamp

)

blinks.

Charge marker helps you remember

whether the battery pack has been

charged or not. Two colours are provided

(red and black)—you choose which one

means charged and which means

discharged.

GR-SXM755_EN 11/8/02, 3:05 PM6