HP OmniBook 800 Installation And Setup Manual
Download Installation and setup manual of HP OmniBook 800 CD/CDR Drive for Free or View it Online on All-Guides.com.
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
73
74
75
76
77
78
79
80
81
82
83
84
85
86
87
88
Starting Out with Your OmniBook
Setting Up the OmniBook
1-5
To set up the OmniBook
See “Battery Safety” in chapter 6 for the proper handling of batteries.
1. Install the battery.
• Lay the battery pack into the battery compartment. The metal battery
contacts on the pack mate with contacts in the compartment.
• Close the two latches.
The battery pack contains rechargeable batteries. The first time you use your
OmniBook, you should charge the battery for 1 or 2 hours before operating
solely on battery power. However, you can operate immediately with the ac
adapter plugged in—see the next section.
2. Connect the ac adapter and start charging.
• Plug the power cord into the ac adapter, then into a grounded ac outlet.
• Plug the connector from the ac adapter into the socket at the right-rear
corner of the OmniBook.
• Important: If you will not be using the ac adapter for an extended period of
time, unplug it from the power source.