Bogen AS1 Installation And Use Manual

Download Installation and use manual of Bogen AS1 Speakers for Free or View it Online on All-Guides.com. This version of Bogen AS1 Manual compatible with such list of devices, as: AS1, ASUG1, ASWG1, ASWG1DK

Brand: Bogen

Category: Speakers

Type: Installation and use manual

Model: Bogen AS1 , Bogen ASUG1 , Bogen ASWG1 , Bogen ASWG1DK

Pages: 2 (0.24 Mb)

Download Bogen AS1 Installation and use manual

Bogen AS1 Installation and use manual - Page 1
1
Bogen AS1 Installation and use manual - Page 2
2
Amplified Speakers
Models AS1, ASUG1(DK), and ASWG1(DK)
Installation and Use Manual
Description
Bogen’s self-amplified ceiling speakers are 8-inch, cone-type loudspeakers, complete with built-in amplifier and volume
control knob.
Installation Instructions for ASUG1(DK) and ASWG1(DK)
Note: Do not mount the speaker near noise generating equipment (fans, motors, etc.) and do not use where a normal
conversation cannot be conducted.
TB8 and RE84 Installation
1. Place ceiling tile with the finished side facing up over a large
trash can (to provide support and save cleanup time).
2. Cut hole in the center of the ceiling tile, using the raw speak-
er as a guide.
3. Bend (4) horseshoe tabs upward on tile bridge.
4. Position the tile bridge on the unfinished side of the ceiling tile
and bend (4) locator tabs into tile opening to prevent sliding.
5. Slip tie-off tabs (2) through RE84 tie-off tab slots until they
click into place and secure customer-supplied “tie-off” wire to
tab.
6. Punch out knockout in the RE84. Install listed metallic enclo-
sure entry fitting to knockout to accommodate plenum cable
or plenum. Whip and feed cable or whip through the knock-
out.
7. Install RE84 to tile bridge by orienting horseshoe tab slots (4)
over horseshoe tabs (4) of bridge.
8. With pliers, twist horseshoe tabs (4) of tile bridge 1/2 turn,
securing enclosure to bridge.
9. Screw the Ceiling Speaker assembly to the RE84 using (4)
8-32 screws provided with the Ceiling Speaker assembly,
sandwiching the TB8 and ceiling tile in between. The screws
must go through the TB8 clearance holes as shown. (Screws
anchor into the RE84.)
© 2004 Bogen Communications, Inc.
All rights reserved.
Specifications subject to change without notice.
54-5850-02C 0804
Model Style
Power
Requirements
Power
Rating
Mounting Accessories
AS1
Unmounted Cone Speaker with 1W Amplifier and
Volume Control
1 CU
(50 mA)
1W
Grilles: CG8A, CG8AW,
SG8W, PG8A, PG8U, PG8W
ASUG1,
ASWG1
AS1 Mounted onto Steel Ceiling Grille (PG8U or PG8W)
with Fixed, Volume Control Knob
TB8, RE84, MR8
ASUG1DK,
ASWG1DK
AS1 Mounted onto Steel Ceiling Grille (PG8U or PG8W)
& Detachable Volume Control Knob