HP DesignJet Series Service Manual
Download Service manual of HP DesignJet 1055CM Plotter, Printer for Free or View it Online on All-Guides.com.
2- 9
Syste
m
Error Codes
HP Designjet Entry- level Printers Service M anual
Syste m Error: 81:01
Proble m
Descriptio n:
Paper- Axis shutdown - usually a p aper-ja
m
caused by a blockage of the
Paper- axis Syste
m
.
Corrective Actio n: Try the following:
If this error code was caused by a p aper-ja
m
, unplug the power cable
fro
m
the printer and cle ar the blockage. Plug in the power c able again
and check if the Error Code has disappeared
If this error code appeared but was N OT caused by a paper ja
m
,
repl ace the Paper- Axis Motor Drive Asse
m
bly Page 7-75.
Syste m Error: 81:1 2
Proble m
Descriptio n:
Media Advance error.
Corrective Actio n: This error usually appears during the paper- advance c alibration -
R
etry the
paper- advance calibration.
Syste m Error: 83:1 0
Proble m
Descriptio n:
Sheet feeding failure.
Corrective Actio n: Try the following:
R
epl ace the O ut- O f- paper Sensor.
R
epl ace the Electronics Module Pa ge 7- 18.
Syste m Error: 85:1 0
Proble m
Descriptio n:
Paper- Axis Encoder error.
Corrective Actio n: Try the following:
M ake sure that the Encoder Sensor cable is connected correctly.
R
epl ace the Paper- Axis Motor Drive Asse
m
bly Pa ge 7-75.
R
epl ace the Electronics Module Pa ge 7- 18.
Syste m Error: 86:01
Proble m
Descriptio n:
Sc an- axis shutdown - usually a paper-ja
m
caused by a blockage of the Scan-
axis Syste
m
.
Corrective Actio n: Try the following:
Check that there are no obstacles in the Scan- Axis which stops the
C arriage fro
m
m
oving freely.
Too
m
uch friction in the Slider
R
od, try lubricating the Slider
R
od.
The C arria ge is bu
m
ping into the Service Station. If the C arriage is stuck
at the right hand side of the Printer and cannot be
m
oved out to the
center of the Print Platen it is because the Service St ation cannot uncap