US Fleet Tracking USFT NT-X5 Install Manual
Download Install manual of US Fleet Tracking USFT NT-X5 GPS for Free or View it Online on All-Guides.com.
Brand: US Fleet Tracking
Category: GPS
Type: Install manual for US Fleet Tracking USFT NT-X5
Pages: 2
1
2
Install
NT-X5
The USFT NT-X5 Install Guide
USFleetTracking
Please verify that your device is activated prior to installation.
When activating a unit, refer to the device MID# on the top of the
tracking device. (Reference Image A.)
The NT-X5 requires a standard 3-wire installation to operate effectively.
Please familiarize yourself with the following wire colors and functions.
The red wire (power) should be directly wired to a constant 8V - 16V power source found at the
key source or fuse panel.
The black wire (ground) should be securely fastened to a grounded screw or to chasis ground.
The white wire (ignition) is the ignition event wire that is best installed directly to the ignition wire.
Ensure that power to the ignition wire is available ONLY when the vehicle ignition is turned on. All
makes and models of vehicles are different - we recommend you make sure that you know your
particularvehicle’sConstantandIgnitionwiresandtheirspeciccolor(s)priortoinstallation.
The green, brown and yellow wires (outputs) can be used to honk the vehicle’s horn, unlock its doors
remote start the engine, and disable/enable the starter.
The blue, orange, purple, and grey wires (input) can be used to monitor many functions such as PTO
activity(PowerTakeOff),emergencylights,panicswitch,etcoraspeciedinputforthecustomer.
Step 1 > Wiring and Installation
405.726.9900 | 2912 NW 156th Street | Edmond, Oklahoma 73013 | usft.com
Thank you for purchasing your new GPS vehicle tracking system!
Installation of your new GPS tracking device couldn’t be easier.
Just follow these simple steps.
Step 2 > Status LED Lights
After installing the unit, and prior to securing under the dash area, make
sure the unit has a solid green light and a blinking orange light that goes
solid for 1 second, then repeats the pattern. See table on page 2 of this
Installation Guide for troubleshooting when one or both does not occur.
(Reference Image B and Table on Page 2.)
Image A
Image B
Red wire
Black wire
White wire
Green wire
Brown wire
Power
Ground
Ignition input
Starter kill
Honk Horn
12 VDC constant
Ground
Key (on)
Output (150 mA)
Output (150mA)
* Must be connected for device to work properly.
*
*
*
Unlock Door
PTO 2 (panic)
PTO 3
PTO 4
PTO 5
Yellow wire
Blue wire
Orange wire
Purple wire
Grey wire
Output (150 mA)
Input - Bias low
Input - Bias high
Input - Bias high
Input - Bias high