Bose Model 101 Music Monitor Series II Owner's Manual

Download Owner's manual of Bose Model 101 Music Monitor Series II Speakers for Free or View it Online on All-Guides.com.

Bose Model 101 Music Monitor Series II Owner's manual - Page 1
1
Bose Model 101 Music Monitor Series II Owner's manual - Page 2
2
– + – +
R L
• • • •
– +
• •
Left Speaker
– +
• •
Right Speaker
Figure 1
Connect the wire from the positive (red) terminal on each speaker to the
corresponding positive terminal on your receiver. Similarly, connect the
wire from the negative (black) terminal on each speaker to the negative
terminal on your receiver.
Receiver or Amplifier
Figure 2
Connect a speaker cord to each 101
®
Series II
speaker by depressing the tabs and inserting
the bare ends of the wires. Connect the posi-
tive wire to the red terminal and the negative
wire to the black terminal.
Phasing Test
To make sure that your speakers are connected to your receiver in phase (positive
to positive and negative to negative) perform this simple test:
1. Set your receiver or amplifier to MONO if that is an option. Set the balance
control to the middle (normal) position.
2. Temporarily place the loudspeakers so they are facing each other at close
range.
3. Play some deep bass passages of music through the speakers. The sound
should seem to come from a point directly between the speakers, with full, rich
bass.
4. If the music seems to be lacking in deep bass, reverse the + and – connec-
tions on one speaker and repeat the test. Use the connection which produces the
most powerful bass.
Using the Speakers with a TV
To use your 101 Series II speakers in an audio/video system, be sure to place the
speakers at least nine inches from the television monitor. This prevents interfer-
ence with the picture quality.
Problem Reason/Solution
Only one speaker plays. One speaker wire is improperly connected. Check
the wires and connections. See Figure 2.
Adjust the balance control on your receiver or
amplifier.
Neither speaker plays. Your receiver or amplifier is set for operation with
headphones only. Reset your receiver or amplifier.
The tape monitor switch on your receiver or ampli-
fier is in the on or tape position. Reset the tape
monitor switch.
Weak bass. Speakers may be out of phase. Perform the
“Phasing Test” and reconnect them.
Maintenance
To clean your speakers, turn off your receiver or amplifier. Then, simply wipe with
a damp cloth. Be sure to keep moisture away from the speaker terminals.
Warranty
The Bose
®
101
®
Series II Music Monitor
®
speaker system is covered by a limited
five year warranty.
In Case of Difculty
If your 101 Series II speaker system exhibits any of the following problems, try the
suggested solutions before returning it for service.
If you are still having trouble with your speakers, please contact Bose at 1-800-
367-4008 to verify any defect and arrange for service. Bose Corporation will make
every effort to remedy any problem within the terms of the warranty.
Accessories
To make your Bose 101 Series II speaker system even more flexible and fun, the
following accessories are available from your Bose dealer, or directly from Bose
Corporation. For information call 1-800-444-2673 between 8:30 am and 9:00 pm
eastern time.
Accessory Description Model Part Number
101 Wall Bracket Mounts your 101 Series II
speaker on a wall or other surface.
101 Travel Bag Transports two 101 Series II
speakers from place to place,
easily and safely.
WB-10 125384
TB-2 134899