Dell Z9000 Installing
Download Installing of Dell Z9000 Network Router, Switch for Free or View it Online on All-Guides.com.
Access ports | 33
7
Access ports
The Z9000 has 2 management ports available for system access: a console port and a USB-B port. The
USB-B ports acts exactly as the console port. The terminal settings are the same for both access ports.
Access the RJ-45 console port (RS-232)
NOTE: Before starting this procedure, be sure you have a terminal emulation program already installed on
your PC. Contact Dell Force10 Networks Technical Support for assistance.
The RS-232 console port is labeled on the Z9000 chassis. It is in the upper right-hand corner, as you face
the I/O side of the chassis.
Figure 7-1. Z9000 serial console port connector
To access the console port, follow the procedures below. Refer to
Table 7-1
for the console port pinout.
Step Task
1 Install an RJ-45 copper cable into the console port. Use a rollover cable to connect the Z9000 console port to a
terminal server.
2 Connect the other end of the cable to the DTE terminal server.
3 Default terminal settings on the console are set as follows:
• 9600 baud rate
• No parity
• 8 data bits
• 1 stop bit
• No flow control
RJ-45/RS-232
Console Port
Primary Management
(Ethernet) Port