Desa PC-BVBN Installation Instructions

Download Installation instructions of Desa PC-BVBN Cooktop for Free or View it Online on All-Guides.com.

Brand: Desa

Category: Cooktop

Type: Installation instructions for Desa PC-BVBN

Pages: 4

Download Desa PC-BVBN Installation instructions

Desa PC-BVBN Installation instructions - Page 1
1
Desa PC-BVBN Installation instructions - Page 2
2
Desa PC-BVBN Installation instructions - Page 3
3
Desa PC-BVBN Installation instructions - Page 4
4
Parts included with this kit:
Part No. Description Quantity
Instruction Sheet 1
105798-04 Pilot Orifice, Propane/LP 1
105523-02 Burner, Propane/LP 1
104506-04 Main Burner Orifice (1.39mm) 1
105799-02 Gas Valve Regulator 1
105801-02 Conversion Label, English 1
106038-02 Conversion Label, French 1
106080-01 Conversion Information Label 1
Tools Required
10mm Open End Wrench 3/8" Socket, Nut Driver or
5/16" Socket or Nut Driver Slotted Screwdriver
18mm Open End Wrench or #2 Phillips Screwdriver
Adjustable Wrench 7/16" Open End Wrench
3/4" Open End Wrench or Needle Nose Pliers
Adjustable Wrench High Temperature Silicone Sealant
7/8" Open End Wrench or (GE RTV 106/Loctite RTV 81585)
Channel Lock Pliers Thread Sealant (Resistant to Propane/LP)
If any of these pieces are missing or damaged, contact the dealer where you purchased this
kit or DESA International at 1-800-972-7879 for referral information.
INSTALLATION INSTRUCTIONS
FOR PC-BVBN (02285)
CONVERSION KIT
NATURAL GAS TO PROPANE/LP GAS
For Use When Converting Models SBVBN(A) or CBVBN(A)
INTERNATIONAL
This conversion kit must be installed by a qualified service agency.
Read these instructions completely before installing this conversion kit.
Before proceeding, make sure the gas control valve is in the “OFF” position, all electrical
power to the appliance is OFF, and the fireplace is cool to the touch.
CAUTION: The gas supply shall be shut off prior to disconnecting the
electrical power before proceeding with the conversion.
REMOVING GLASS DOOR
The glass door must be removed to allow
access inside the firebox chamber for con-
version. To remove the glass door, the front
panel on the stove body must be removed.
1. To remove the stove front panel, re-
move two 10mm hex bolts from bot-
tom of stove and one phillips head bolt
from top of stove (see Figure 1).
2. Using a 3/8" socket or slotted screw-
driver remove the screws from the two
tabs at the top of the glass door (see
Figure 2, page 2). Hold glass door se-
curely to keep it from falling forward.
3. Grasp door by both sides and ease it
upward off the lower bracket (see Fig-
ure 2, page 2).
Bolt (Phillips
Head)
Figure 1 - Removing Stove Front Panel
Bolt (10mm Hex)
Stove Front Panel
Note:
Appearance of
Stove Body may vary
depending on Model