HP J7974E Administrator's Manual
Download Administrator's manual of HP J7974E Print Server for Free or View it Online on All-Guides.com. This version of HP J7974E Manual compatible with such list of devices, as: J7974E, J7987E, J7990E, J7991E, J7993E
Brand: HP
Category: Print Server
Type: Administrator's manual
Model: HP J7974E , HP J7979E , HP J7982E , HP J7987E , HP J7990E , HP J7991E , HP J7992E , HP J7993E
Pages: 186
0 disables, 1 (default) enables.
phone-home-config Specifies privacy settings on the print server during embedded Web server access. This
command controls whether statistical data on product use may be sent to HP. For HP to
collect data, Internet access is required.
2: Prompt the user to allow sending data on initial access to the Networking tab of the
embedded Web server. This is the factory-default and cold-reset value. Once changed,
this value cannot be re-selected.
1: Allows the sending of data to HP without prompting the user.
0: Disables sending data to HP without prompting the user.
TCP/IP Diagnostics
Last Config IP
(Read-only parameter) The IP address of the system from which the HP Jetdirect print
server's IP address was configured.
TCP Conns Refused (Read-only parameter) The number of client TCP connections that are refused by the print
server.
TCP Access Denied (Read-only parameter) The number of times that client systems were denied access to the
print server because there was no allowable entry in the print server's host access list.
DHCP Lease Time (Read-only parameter) DHCP IP address lease duration time (seconds).
DHCP Renew Time (Read-only parameter) DHCP T1 timeout, specifying the DHCP lease renewal time
(seconds).
DHCP Rebind Time (Read-only parameter) DHCP T2 timeout, specifying the DHCP lease rebind time
(seconds).
SNMP
snmp-config
Enables or disables SNMP operation on the print server. 0 disables, 1 (default) enables
SNMP.
CAUTION Disabling SNMP will disable all SNMP agents (SNMP v1, v2, v3) as
well as communications with management applications, such as HP Web
Jetadmin. In addition, firmware upgrades through current HP downloading utilities
will be disabled.
get-cmnty-name Specifies a password that determines which SNMP GetRequests the HP Jetdirect print
server will respond to. This is optional. If a user-specified get community name is set, the
print server will respond to either a user-specified community name or the factory-default.
The community name must be ASCII characters. The maximum length is 255 characters.
set-cmnty-name Specifies a password that determines which SNMP SetRequests (control functions) the
HP Jetdirect print server will respond to. The community name of an incoming SNMP
SetRequest must match the print server's “set community name” for the print server to
respond. (For additional security, you may limit configuration access through the print
server's host access list.) Community names must be ASCII characters. The maximum
length is 255 characters.
default-get-cmnty Enables or disables the default Get community name.
0 disables, 1 (default) enables.
Disabling this parameter may prohibit communications with SNMP management
applications.
SNMP Traps
Table 3-3 Telnet Commands and Parameters (continued)
50 Chapter 3 TCP/IP Configuration ENWW