• Home
• Brands
• Maytag Manuals
• Maytag 27" SINGLE WALL OVEN
• Maytag 27" SINGLE WALL OVEN Installation Instructions

Maytag 27" SINGLE WALL OVEN Installation Instructions

Download Installation instructions of Maytag 27" SINGLE WALL OVEN Oven for Free or View it Online on All-Guides.com.

1

2

Installing Bottom Trim Piece

Electrical Connections

Unit to be properly circuit protected and wired according to

local electrical code and National Electrical Code.

It is advisable that the electrical wiring and hookup be

accomplished by a competent electrician.

120/240 VAC or 120/208 VAC 60 Hz. See serial plate on

front of unit for power requirements.

The neutral of this unit is grounded to the frame through the

green or solid grounding wire. (The green and the white

wires are twisted together at the termination of the conduit.)

If local conditions do not permit grounding of the neutral,

untwist the green wire and connect the green wire to

ground in accordance with local codes. Connect the white

neutral to the service neutral.

The chart below recommends the minimum circuit

protection and wire size if the appliance is the only unit on

the circuit.

When installing a 27" walloven under a 30" cooktop some

interference may occur. The following cutout notching of

the side trims will eliminate the interference of the side trim

to the burner box. After cutting, file the side trim edges to

eliminate burrs.

Service

Interrupt the source of electricity to the unit when attempting

to repair or service the oven. Failure to do this could result

in a dangerous or even fatal shock.

RECOMMENDED MINIMUM

K.W. RATING CIRCUIT PROTECTION WIRE SIZE

ON SERIAL PLATE IN AMPERS (AWG)

15,0 -14.8 20 12

14.9 -16.9 30 10

17.0 -19.9 40 18

10.0 - 11.9 50 18

12.0 - 14.9 60 16

IMPORTANT - SAVE FOR LOCAL ELECTRICAL INSPECTOR'S USE

8101P306-60

(04-99-01)

CAUTION

For European style cabinets (flush front) the required

clearance for operation of the oven door is minimum

spacing of 7/8" between the cutout and the door,

hinge or drawer of the cabinet.

Some built-in cabinets may not be wide enough,

due to their construction, to allow this installation.

1. Cut hole in cabinet to mount oven. Cutout in cabinet

should be level and straight.

Note: There are no provisions to level the unit after it

is installed. An oven that is not level could

cause poor baking results.

2. Install plywood floor as shown.

3. Attach unit to the cabinet with four No. 8x1" screws

supplied with unit inside of envelope containing these

instructions. Pre-drill holes in cabinet for attachment

screws using 1/8" drill. Oven mounting holes are

provided in side trim.

4. See instructions at right for electrical hook-up.

5. See Use and Care Manual for operating instructions.