EarthWay 2170 Assembly And Operating Instructions Manual

Download Assembly and operating instructions manual of EarthWay 2170 Spreader for Free or View it Online on All-Guides.com.

Brand: EarthWay

Category: Spreader

Type: Assembly and operating instructions manual for EarthWay 2170

Pages: 6

Download EarthWay 2170 Assembly and operating instructions manual

EarthWay 2170 Assembly and operating instructions manual - Page 1
1
EarthWay 2170 Assembly and operating instructions manual - Page 2
2
EarthWay 2170 Assembly and operating instructions manual - Page 3
3
EarthWay 2170 Assembly and operating instructions manual - Page 4
4
EarthWay 2170 Assembly and operating instructions manual - Page 5
5
EarthWay 2170 Assembly and operating instructions manual - Page 6
6
PLEASE CALL US IF YOU HAVE ANY DIFFICULTY WITH THIS
SPREADER BEFORE RETURNING TO THE STORE. WE CAN BE
REACHED VIA PHONE AT 800-294-0671 OR 574-848-7491
M
ONDAY—FRIDAY 9:OOAM ~ 3:00PM OR ONLINE AT
WWW.EARTHWAY.COM
ASSEMBLY and OPERATING INSTRUCTIONS
for
EarthWay
EV-N-SPRED
®
MODEL 2170
Broadcast Spreader
REV. 9-06
HELPFUL HINTS: READ THE DIRECTIONS BEFORE ASSEMBLY
If your spreader does not spread evenly, be sure the FRONT on the gear box points to the front of the spreader. The impeller must
turn clockwise. Reversing the gearbox will cause the impeller to turn counter clockwise. Clean the impeller plate after each use.
Fertilizer stuck on the impeller blades will cause uneven spreading.
Your spreader is designed to be pushed at three miles per hour, which is a brisk walking speed. Slower or faster speeds will change
the spread patterns. Wet fertilizer will also change the spread pattern and flow rate. Clean your spreader thoroughly after each use.
Wash between the shut off plate and bottom of the hopper.
Gears are permanently lubricated at the factory. Do not open the gearbox or dirt may enter.
When using Rock Salt remove the agitator to prevent damage to the gearbox and remove salt from the hopper daily. Rock Salt will
reconstitute back into a solid block over night with humidity.
1. Remove and identify loose parts from carton.
2. Position hopper on side. Install frame using (4) 1/4-20
x 1-½” Pan Head Philips machine screws and (4) 1/4-20
nylon insert locknuts. First, put bolts through holes in
frame, then through holes in bottom of hopper. Secure with
locknuts. Tighten these locknuts now.
PAGE 1
Pt. #52164
ROCK SALT IS NOT RECOMMENDED FOR USE IN
THIS SPREADER. REMOVE AGITATOR WHEN
USING ICE MELT.