• Home
• Brands
• Jensen Manuals
• Jensen EHT-2
• Jensen EHT-2 User Manual

Jensen EHT-2 User Manual

Download Operation & user’s manual of Jensen EHT-2 Speakers, Speaker System for Free or View it Online on All-Guides.com. This version of Jensen EHT-2 Manual compatible with such list of devices, as: EHT-2, EHT-4, EHT-5, EHT-6, EHT-8

1

2

EHT-2/4/5/6 and 8

In Wall / Ceiling models

Congratulations on investing in JENSEN’s Architectural Speaker

Systems. You will find this information valuable for the long-term

enjoyment of your speaker system.

Break In Period. Certain parts and materials are used in these EHT-2/4/5/6/8 products so

maximum performance can be obtained in damp and dusty environments such as wall and ceiling

cavities. Therefore, we strongly advise that you resist temptation to play your JENSEN speakers to

their full capabilities until they have been properly broken in. This process should last appx. 20-40

hours of music playback. This can easily be done by putting your compact disc player on Repeat

mode, while playing a CD with reasonable Bass content at average room volume listening levels.

Installation.

Step 1. Decide the placement for your speakers. Advance planning in regards to the placement of

your speakers is critical. It is imperative that the wall or ceiling cavity be free from debris,

moisture, insulation, and any materials that are easily combustible. The mounting location must

also be void of wall studs or bracing in the location for the cutout. Adequate depth for the speakers

to fit flush to the wall or ceiling surface is important. If you are unsure of the contents of the wall

in which you wish to mount the speakers, simply drill a small hole and using a metal coat hangar,

insert the end of the hangar into the wall and twist it to feel for any debris or wall studs. Electronic

Stud Finders work well also.

Step 2. Once you have determined the final mounting position, use the supplied template and

mark the cutout on the wall or ceiling, depending on the model purchased. To mark the cutout size,

simply trace an outline of the supplied template, found in the box with a pencil.

Step 3. Using the appropriate wall-cutting tool, accurately cut the hole in the wall material, based

on the appropriate cutout dimension.

Step 4. Install speaker cable(s) from the receiver or amplifier to the inside of the wall or ceiling,

and leave enough slack in the wire so that it can hang out of the hole.

Step 5. Connect the speaker wire from the positive (RED+) terminal on the receiver to the

positive (RED+) terminal on the speaker. Connect the negative (BLACK-) the same way to the

negatives. Note: If you inadvertently reverse one of the connections (i.e. RED to BLACK) you will

notice a severe lack of Bass from your system. This is called wiring your system “Out of Phase”. If

this occurs, check the wiring and reconnect as necessary.

Step 6. Remove metal grilles. (see below) For all models, gently adjust eyeball tweeter to aim

towards main listening area. See below for fine-tuning. For models EHT-2/6/8, set Boost switches

to desired setting (see below). Insert the entire speaker into the hole, and using a Phillips

screwdriver, tighten the screws attached to the dog clamps until firm. NIP THESE UP - DO NOT

OVERTIGHTEN. Note: If you are unable to install these speakers yourself, please contact an

authorized electrician or installation contractor.