Haier HWM70-12688NZP User Manual
Download Operation & user’s manual of Haier HWM60-12699NZP Washer for Free or View it Online on All-Guides.com.
Brand: Haier
Category: Washer
Type: Operation & user’s manual
Model: Haier HWM60-12699NZP , Haier HWM70-12688NZP
Pages: 8
1
2
3
4
5
6
7
8
HWM70-12688NZP
HWM60-12699NZP
HWM70-12688NZP
HWM60-12699NZP
1/12 2/18 3/24 4/29
5/33 6/37 7/41 8/46
L 500mm W 520mm H 902mm
No or slow drainthe digitron
displays“E1”,buzzing.
No or slow water fillingthe digitron
displays“E4”,buzzing.
The digitron displays“FA”,buzzing.
The machine does
not act.
Not wash
Not spin
Water level sensor is abnormal?
Please contact with after-sales service
department.
The water tap is not open.
The water inlet valve is blocked.
The water pressure is too low
and the current is too small.
Are the laundries put slantingly?
Is the machine slanting?
Open the tap.Open and close the top lid once,
then press the START/PAUSE button.
Clean the water inlet walve,Open and close the
top once.then press the START/PAUSE button.
Wait for the normal water pressure before use.
Re-order the laundries.Close the top lid and
press the START/PAUSE button.
Safety switch actuates,not spin,
(after self-correction twice),the digitron
displays“E3”,buzzing.
Is the drain hose put down?
Is the drain hose blocked by
foreign material?
Put down the drain hose.Open and close the top
lid oncethen press the
START/PAUSE button
Clean the foreign material.Open and close the
top lid once,then press the
START/PAUSE button
Level the machine in right position
Note: when the digital tube displays the abnormal symbol during working,it buzzs once in
succession every two minutes,then the power will be cut automatically after ten minutes.
When the power plug is inserted, computer
board indicator is switched on, and the
machine starts working.
It is the special resume function. In the case of power
failure or the power plug is loose during washing, the
machine can save the running program, and resume
the program after the power supply is recovered. You
do not need to set the program again.
Is there power failure?
Is the power plug inserted tightly?
Is the water level reached preset
position?
Is the top lid closed?
Use it when there’s power supply.
Insert the power plug tightly.
Fill water to the preset position
Close the top lid
Is the power plug inserted tightly?
Is the top lid closed reliably?
Are the laundries set flat?
Insert the power plug tightly.
Close the top lid.
Set the laundries flat.
There’s abnormal sound
inside the machine
Is the machine slanting?
Are the laundries put slantingly in
spinning?
Adjust the machine to be even.
Reorder the laundries and close the
top lid.
The water tap leaks
Fasten the jointer properly.
Is the jointer of water inlet hose
loose or twisted awry?