Viking VCSB5481 Series Technical Information
Download Technical information of Viking FDSB5481 Kitchen Appliances, Ranges for Free or View it Online on All-Guides.com.
Brand: Viking
Category: Kitchen Appliances , Ranges , Refrigerator
Type: Technical information
Model: Viking FDSB5481 , Viking VCSB5481 , Viking VCSB5481 Series
Pages: 18
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
Mode
A
Parameter
Values
Remarks and procedures
Refrigerator
and
Freezer
Cut-in
1°F
to
10°F
in
increments
of
1°F
Press
and
hold
"ALARM
OFF"
and
"HIGHER"
at
same
time
for
three
seconds
which
will
result
in "OH" beingdisplayed .
Adjustment
-Press
"REF
TEMP"
pad once to select the refrigerator
section, this
will
result in
"REFRIGERATOR"
being illuminated on
the
display
along
with
thecurrent refrigerator cut-in
value.
Using
the
"HIGHERand
LOWER"
pads make sure this value is
6°F.
Adjustment -Press
"FRZ
TEMP"pad once to select the freezersection,
this
will
result in
"REFRIGERATOR"
extinguishing and
"FREEZER"
illuminating on the display along with the current freezer cut-in value.
Using the "HIGHER and
LOWER"
pads make sure the value is 7°E
Exit - Press
ACTIVATE
CONTROLSkey once. The display willshow
"PrA"
to indicatecontrol isstill in Program Mode A.
Refrigerator
and
Freezer
Cut-out
-10°Fto-l°F
in
increments
ofl°F
Press
and
hold
"ALARM
OFF"
and
"LOWER"
at
same
time
for
three
seconds
which
will
result
in
"COH"
being
displayed
.
Adjustment
-Press
"REF
TEMP"
pad once to selectthe refrigerator
section, this willresult in "REFRIGERATOR" being illuminated on
the display along with the current refrigerator cut-out value. Using the
"HIGHER and
LOWER"
pads make sure this value is
-6°F.
Adjustment -Press
"FRZ
TEMP"
pad once to select the freezer section,
this
will
result in
"REFRIGERATOR"
extinguishingand
"FREEZER"
illuminating on the
display
alongwith the current
freezer
cut-out
value.
Using
the
"HIGHER
and
LOWER"
pads
make
sure the
value
is
-7°F.
Exit - Press
ACTIVATE
CONTROLS
keyonce. The display
will
show
"PrA"to indicate control is still in Program Mode A.
Exiting
Program
Mode
A
1. Press and
hold
the
ACTIVATE
CONTROLS key for three (3) seconds. The control
will
change
from
Program
Mode
Ato
Normal
Mode
and
any
changes made
in
Program
Mode
will
be
saved
to
EEPROM.
2.
If
the
keypad
is
not
used
for
ten
(10)
minutes,
the
control
will
automatically
change
from
Pro
gram
Mode
A
to
Normal
Mode
and any
changes
made
in
Program
Mode
will
not
be
saved
to
EEPROM.