Xantech Smartspeaker s-62 Installation Instructions

Download Installation instructions of Xantech Smartspeaker s-62 Speaker System for Free or View it Online on All-Guides.com.

Xantech Smartspeaker s-62 Installation instructions - Page 1
1
Xantech Smartspeaker s-62 Installation instructions - Page 2
2
Xantech Smartspeaker s-62 Installation instructions - Page 3
3
Xantech Smartspeaker s-62 Installation instructions - Page 4
4
1
Speakers & Volume Controls
INSTALLATION INSTRUCTIONS
S-62, S-64, S-66
SMARTSPEAKER
TM
INTRODUCTION
The SmartSpeaker™ line consists of three physically interchangeable speaker/baffle assemblies,
installation and finishing hardware. The speaker/baffle assemblies feature a cut-out for the 480 Dinky
Link™ Infrared Receiver. The systems are designed to be mounted in a wooden-studded plasterboard or
“lath and plaster” wall. They can be mounted in most ceilings, however special acoustic treatment may be
required. The addition of the Dinky Link Infrared Receiver adds the dimension of wireless remote control
extension to any installation.
DESCRIPTION
R-61 Rough-in Kit
The Rough-in Kit consists of a pair of molded rectangular frames, flat perforated “wings” and thread-
cutting screws.
The Rough-in Kit is mounted to the wooden studs during construction and is installed before the
plasterboard. It is not used in existing construction.
F63 Bezel/Grille
The molded plastic bezel mounts directly to the wall or ceiling, with or without the Rough-in Kit. It is held
in place by four “dogs” which slip through the rectangular wall cutout and rotate into clamping position
as they are tightened.
The bezel can be painted to match the mounting surface after it is installed.
The perforated metal grille should be painted, if desired, before installation.
The grille should be carefully installed after the speaker/baffle assembly has been mounted. Care should
be taken so that the edges of the grille do not scratch the finished surfaces of the bezel. The grille should
be painted, if desired, before installation.