York PC9B12N060UP11 Technical Manual

Download Technical manual of York PC9B12N060UP11 Furnace for Free or View it Online on All-Guides.com. This version of York PC9B12N060UP11 Manual compatible with such list of devices, as: PC9B12N060UP11, PC9B12N080UP11, PC9C16N080UP11, PC9C20N100UP11, PC9D20N120UP11

York PC9B12N060UP11 Technical manual - Page 1
1
York PC9B12N060UP11 Technical manual - Page 2
2
York PC9B12N060UP11 Technical manual - Page 3
3
York PC9B12N060UP11 Technical manual - Page 4
4
York PC9B12N060UP11 Technical manual - Page 5
5
York PC9B12N060UP11 Technical manual - Page 6
6
York PC9B12N060UP11 Technical manual - Page 7
7
York PC9B12N060UP11 Technical manual - Page 8
8
TECHNICAL GUIDE
AFFINITY
MODELS: PC9*UP
GAS-FIRED
CONDENSING / HIGH EFFICIENCY
UPFLOW MODULATING FURNACES
WITH ECM MOTORS
NATURAL GAS
60 - 120 MBH INPUT
Due to continuous product improvement, specifications
are subject to change without notice.
Visit us on the web at www.york.com for the most
up-to-date technical information.
Additional rating information can be found at
www.gamanet.org.
EFFICIENCY
RATING
CERTIFIED
ISO 9001
Certified Quality
Management System
246813-YTG-C-0606
FOR DISTRIBUTION USE ONLY - NOT TO BE USED AT POINT OF RETAIL SALE
DESCRIPTION
These Category IV, highly efficient, compact, condensing
type furnaces are designed for residential and commercial
installations in a basement, closet, alcove, recreation room
or garage where the ambient temperature is above 32°F, or
higher. They may be either side wall or thru-roof vented
using approved plastic type combustion air and vent piping.
All units are factory assembled, wired and tested to assure
dependable and economical installation and operation.
WARRANTY
Lifetime limited warranty on both heat exchangers to the
original purchaser; a 20-year limited warranty from original
installation date to subsequent purchaser.
10-year warranty on the heat exchanger in commercial appli-
cations.
5-year limited parts warranty.
FEATURES
Modulating heating operation includes:
- Modulating gas valve
- Modulating inducer operation
Provides increased comfort level & very quiet unit opera-
tion
Compact, easy to install, ideal height 40" cabinet
Blower-off delay for cooling SEER improvement.
Easy to connect power/control wiring.
Built-in, high level self diagnostics with fault code display.
Low unit amp requirement for easy replacement applica-
tion.
Integrated control module for reliable, economical opera-
tion.
May be installed as either two-pipe (direct vent) or single
pipe vent (using indoor combustion air)
Top intake & vent connection allows installation in narrow
locations.
Electronic Hot Surface Ignition saves fuel cost with
increased dependability and reliability.
Induced combustion system with inshot main burners for
quiet, efficient operation.
No special vent termination kit required.
100% shut off main gas valve for extra safety.
ECM high efficiency direct drive motor with large, quiet
blower.
24V, 40 VA control transformer and blower relay supplied
for add-on cooling.
Hi-tech tubular aluminized steel primary heat exchanger.
Secondary (condensing) heat exchanger of 29-4C high-
grade stainless steel.
Solid removable bottom panel allows easy application.
Easy access from front of unit for cleaning, maintenance
or service.
Protection from intake, exhaust or condensate blockage.
Insulated blower compartment for quiet operation.