• Home
• Brands
• Vaillant Manuals
• Vaillant V 12-025 W
• Vaillant V 12-060 M2W Installation Manual

Vaillant V 12-060 M2W Installation Manual

Download Installation manual of Vaillant V 12-025 W Air Conditioner for Free or View it Online on All-Guides.com. This version of Vaillant V 12-025 W Manual compatible with such list of devices, as: V 12-025 W, V 12-060 M2W, V 12-035 W, V 12-050 W, V 12-060 W

1

2

3

4

5

6

7

8

9

10

11

12

13

14

15

16

17

18

19

20

21

22

23

24

25

26

27

28

Split Type Installation Manual

12

9 Installation of the Indoor Unit

9.1 Selecting the Indoor Unit Location

Warning

!

Danger of breakdowns or malfunction.

Observe the minimum clearances indicated in

Figure 8.1.

Note!

If a hole already exists in the wall or a refrigerant

pipe or condensed water pipe has already been

installed, the base plate should be mounted to

suit these conditions.

Recommendations

- Install the indoor unit close to the ceiling, ensuring

minimum clearances are met.

- Choose a position that will allow air to reach all parts

of the room evenly. Avoid beams, obstructions or

lights which would interfere with the airflow.

- Install the indoor unit at an adequate distance from

chairs or workstations in order to avoid unpleasant

draughts.

- Avoid installing close to heat sources.

9.2 Fixing the mounting Plate

Carry out the steps described below:

• Place the mounting plate on the chosen installation

point.

• Level the plate horizontally and mark the position of

holes to be made on the wall.

• Remove the plate.

Warning

!

Danger of interference to other services.

Check that there are no electricity lines, pipes or

any other services which could be damaged

where the holes are to be drilled.

If other services are found, choose another

installation location and repeat the

aforementioned steps.

• Make the holes using a drill and insert the wall plugs.

• Place the mounting plate in position, level it

horizontally and fix it with the screws provided into

the wall plugs.

Warning

!

Danger of breakdowns or malfunction.

Ensure that the mounting plate has been

correctly levelled.

Otherwise, remove the plate and re-fix it again

correctly. Failure to do so could lead to water

leaks.

9.3 Installation of the pipe work

9.3.1 Correct removal of condensate water

Warning

!

Danger of breakdowns or malfunction. Danger of

condensed water leakage.

In order to ensure that the unit drains correctly

take the recommendations described in this

section into account.

Methods for the removal of the condensed water which

is generated in the indoor unit:

- Condensed water can be allowed to drain naturally

using the natural fall of the condensed water drain

pipe to a suitable drain point. In order for it to be

aesthetically pleasing, use solid pipework or trunking

to cover the flexible pipework.

- Alternative installation solutions are also available.

- For example, using an external pump for condensed

water, carrying the condensed water to outside or to

the main drainage system.

- By natural fall to which is then emptied using a pump

for condensed water. The pump which operates when

the tank is full, pumping the water to a suitable drain

point.

Warning

!

Danger of breakdowns or malfunction. Danger of

condensed water leakage.

To ensure that the unit drains properly when

using a natural fall, the condensed water pipe

must also have an adequate fall from the indoor

unit.

9 Installation of the Indoor Unit