Campbell Sierra Wireless AirLink RV50 Quick Manual
Download Manual of Campbell Sierra Wireless AirLink RV50 Gateway, Modem for Free or View it Online on All-Guides.com.
1
2
Do not operate the Sierra Wireless modem in areas where blasting is in
progress, near medical equipment, near life support equipment, or any
equipment which may be susceptible to any form of radio interference. In
such areas, the Sierra Wireless modem MUST BE POWERED OFF. The Sierra
Wireless modem can transmit signals that could interfere with this equip-
ment.
• SIM card from provider (mini-SIM)
• APN information from provider
• #1 Phillips (pn 6290) or 2.5 mm at (pn 8125) screwdriver
• Computer with Ethernet port
• Ethernet cable (supplied)
• DevCong version 2.10 or greater. https://www.campbellsci.com/devcong
1. Use a #1 Phillips (pn 6290) or 2.5 mm at (pn 8125) screwdriver to remove the
SIM card cover.
2. Slide the mini-SIM (2FF) card into the upper SIM card slot until it clicks into
place.
By default, the SIM card in the upper slot is the primary SIM. Note the location
of the notched corner for correct alignment. The gold contact points of the SIM
face down when inserting into the upper slot. They face up when inserting into
the lower slot. To eject a SIM card, press it in slightly and release.
3. Reattach the cover.
1. Connect the Cellular antenna.
2. Connect the Diversity antenna, if used.
Note: If a Diversity antenna is used, use ACEmanager to enable WAN/
Cellular | RX Diversity.
3. Connect the power cable leads to the power supply.
Lead Color Function Connect To
Black Ground G
White Enabled (On/O) 12V (or SW12V or C- or U- for control)
Red Power (7–36 V) 12V
4. Connect the power cable to the RV50 DC Power input.
When the RV50 is properly set up and powered, the status LEDs will turn
on. The RV50 will begin the activation/provisioning process and attempt to
connect to the mobile network. This process typically takes 5-10 minutes. A
successful connection is indicated by a solid green Network LED. If the RV50
does not automatically connect to the network, proceed to Conguration (Step
5) to conrm or enter the WAN/Cellular APN information.
Info
Link
Sierra Wireless
AirLink RV50
Wireless Modem
QUICK DEPLOY GUIDE
IMPORTANT NOTE: This Quick Deploy Guide is meant to be a general
reference to give the installer an overview of the steps required to
make this system operational. The Instruction Manual is the denitive
source for detailed installation instructions and information.
1
Caution!
!
2
Required Hardware/Software
3
Install the SIM Cards
4
Set Up and Power the RV50
Part Number 31887
03/2016