L.L.Bean OJBL1 Setup Instruction Manual
Download Setup & instruction manual of L.L.Bean OJBL1 Pedometer for Free or View it Online on All-Guides.com.
1
This setup instruction guide will show you the easy steps
to set up your L.L.Bean Stowaway Pocket Pedometer
OJBL1.
A Unpack
Make sure you have all the parts shown here before
setting up your pedometer.
1 x Pedometer
B Activate Pedometer
1. Remove the pedometer from the belt clip.
2. Pull plastic strip to activate battery in pedometer.
Plastic strip
Battery Door
C Set up
Once battery is activated, the pedometer automatically
enters the setting mode.
TIP To enter manually at any time after that, press SET.
To toggle between different setting modes:
1. Press
SET once to enter setting mode. SETUP
will be displayed.
Within each setting (Stride, Weight, Time, Alarm and
Beep tone), there are several items to set. To skip to the
next setting, press
SET, or wait 3 seconds for the unit to
automatically move to the next item on the list.
To change values for each setting:
1. Press DISP
or MEM .
NOTE The pedometer automatically moves to the next
setting within 3 seconds. If there is no input / change
made, the unit will use the default value.
2. Wait 3 seconds to move to next item.
Repeat steps 1-2 above for all items.
The settings order is:
Display Setting Title Items to set
(Press
DISP or
MEM )
Main Setting
Stride Measurement unit
(cm / in)
Length
Weight Measurement unit
(lb / kg)
Weight
Time 12 / 24 hour format
Hour
Minute
Alarm Alarm On / Off
Hour (Only if Alarm
ON has been
selected)
Minute (Only if
Alarm ON has been
selected)
Beep Tone On / Off
Final display
D Replace batteries
The pedometer uses a CR2032 3V battery, which has
already been installed.
When is displayed, battery power is low.
1. Remove the pedometer from the belt clip.
2. Open the battery compartment lid, located at the
back of the pedometer by removing the screw.
3. Insert the battery, matching the polarities with
the positive pole facing up.
4. Replace the lid by screwing it back into place.
After each battery change, remember to set up
the unit again (refer to Section C Set Up above)
SETUP INSTRUCTION GUIDE
SET
SET
SET
SET
SET
SET
P/N:300102429-00003-10