• Home
• Brands
• KMC Controls Manuals
• KMC Controls STW-6010
• KMC Controls STW-6010 Installation Manual

KMC Controls STW-6010 Installation Manual

Download Installation manual of KMC Controls STW-6010 Kitchen Appliances for Free or View it Online on All-Guides.com. This version of KMC Controls STW-6010 Manual compatible with such list of devices, as: STW-6010DW, STW-6010NW, STW-6014DW, STW-6014NW, THW-1102DW

1

2

Wireless Temperature and Humidity Sensors

STW-6010, STW-6014, THW-1102

Specifications and design subject to change without notice.

Mounting

Select a location

Install the sensor on an inside wall where it can

sense the average room temperature. Avoid locations

with direct sunlight, heat sources, windows, air

vents, and air circulation or obstructions such as

curtains, furniture, etc.

 Mount the sensor in an area with a minimum

illumination of 200 lux for three to four hours

everyday. The light source can be either artical

or daylight. The health and safety at work act

requires a minimum illumination of 500 lux for

oce workplaces.

 The long term illumination should not exceed

1000 lux.

 Avoid recessed areas that are not suciently

illuminated throughout the day.

 When using collimated articial light the angle

of incidence on the solar cell should be not too

steep.

 The sensors can be mounted with the solar cell

toward a window but not in direct sunlight.

Even occasional direct sunlight can lead to false

temperature values.

 Consider the future use of the room and avoid

locations that may be used for ling cabinets,

shelf units, or other large obstructions.

 In closed spaces with several walls, the maximum

range may be less than 33  (10 m). In open areas,

place the sensor no farther away than 98 . (30 m)

from the receiver or gateway. See the publication

Planning Guide For Wireless Sensor Networks for

details.

Remove the sensor body from the back panel

The sensor body is held to the black, back panel by

three, small, round pegs that t in the holes of the

sensor body. The boom peg is a spring tab and

snaps into the center boom hole.

1. With a small Phillips screwdriver or hex wrench,

press in and hold the tab buon that snaps into

the center hole on the boom cover.

2. Carefully pull or pry the back panel from the

sensor body.

Install the optional battery

A single CR1225 lithium coin baery may be

installed for locations that do not have enough

sustained light to maintain sensor operation.

3. Remove the sensor body from the back panel.

4. Position the CR1225 baery with the plus (+)

symbol visible.

5. Slide the baery into the baery holder.

6. Install the sensor.

STW-6010 and THW-1102 STW-6014

Installation Guide

CR1225 lithium

coin battery

Battery holder