Budda Superdrive 30 Series II Quick Manual
Download Manual of Budda Superdrive 18 Series II All-tube amplifier, Amplifier for Free or View it Online on All-Guides.com.
Brand: Budda
Category: All-tube amplifier , Amplifier
Type: Manual
Model: Budda Superdrive 18 Series II , Budda Superdrive 30 Series II , Budda Superdrive 80 Series II
Pages: 3 (0.48 Mb)
1
2
3
on go master bass mid treble drive rhythm
off rest pull channel pull modern pull brite footswitch
input
Superdrive 30 Series II Manual
Thank you for purchasing the finest tube amplifier in the business. We appreciate your support and
look forward to providing you with years of trouble free service. Before we get into the features of your
amplifier, we would like to note that tube amplifiers require a little bit of care and maintenance that we
would like to share with you. When you first turn on your amplifier remember to leave it on rest for
at least 30 seconds before turning it to go. This will give the tubes plenty of time to warm up and will
extend tube life. The chassis is built out of aluminum which is a conductor of heat. It may feel warm to
the touch, but no need to worry.
Check to make sure that the impedance switch is set to the correct ohmage for your cabinet. Improper
loading may cause excess tube and transformer wear and eventual failure. Use high quality speaker and guitar
cables to ensure maximum performance. For tube related problems, we’ve included a trouble shooting
section on page three off your manual.
Now, lets take a look at the features of your amp by starting with the front panel.
On / Off - Power on and off switch
Go / Rest - Standby control
Master - Controls the overall volume of your amplifier.
Pull channel - Access the hi gain channel by pulling out, for rhythm channel leave pushed in
Bass - Controls the bass frequency of your amp
Mid - Controls the mid range frequencies of your amp by adding and cutting from bass and treble
Pull Modern - Reduces mids while increasing bass and treble frequencies so that your amp has more presence
Treble - Controls the treble frequency’s of your amp.
Drive - Controls the overall amount of distortion of your hi gain channel
Rhythm - Controls the gain and volume of your clean channel
Pull Brite - Adds treble boost to your rhythm channel.
Input - Instrument input
Footswitch - 1/4” jack for footswitch that channel switches your amp between clean and hi gain channels.
pg1