OpenEye EasyDVR Quick Start Manual

Download Quick start manual of OpenEye EasyDVR DVR for Free or View it Online on All-Guides.com.

Brand: OpenEye

Category: DVR

Type: Quick start manual

Model: OpenEye EasyDVR , OpenEye OE1-D

Pages: 2

Download OpenEye EasyDVR Quick start manual

OpenEye EasyDVR Quick start manual - Page 1
1
OpenEye EasyDVR Quick start manual - Page 2
2
POWER Press and hold
this key to trigger the quick
shutdown function.
REC Blinks when live video is recording.
IR Receives infrared signal
from the included remote
controller
NETWORK Illuminates when
the recorder is connected to a
network.
USB Connect a ash
drive for backup or USB
keyboard.
MENU Open the
conguration menu.
SEQ Trigger automatic
camera sequencing.
ESC/LOCK Cancel a selection
or exit a menu.
ENTER Select a menu
option or conrm a
selection.
DIRECTIONAL Navigate
menu items or change a
selected value.
ALARM Blinks when an
alarm is triggered.
NUMERIC
Live and Playback modes: Press any
key to view the corresponding video in
full-screen.
Input interface: 1~4 can be used for direct
input of numbers 1~4.
PTZ mode: Press 1 to enter the Set/ Go
preset menu.
PTZ Enter PTZ mode.
PLAY/STOP
Start/Stop playback.
BACKUP Open the
Backup menu and select
export options.
DISPLAY Cycle
through the available
camera views.
SEARCH Open the Search menu.
FREEZE Freeze the
current image in live or
playback mode.
30726AA
EASYDVR
4CH 120 IPS
H.264 DVR
Logging in for the First Time
User ID: admin
Password: 1234
Note After logging in for the rst time, change the admin password for
the DVR and remote software to establish user level security. See
the User Manual for instructions.
How to Use the IR Remote Controller
When more than one OpenEye EasyDVR is installed in the same location,
you can use one remote controller to control up to 16 recorders. To
control multiple recorders, you must change the remote controller ID to
match the Unit ID of the recorder. Follow the instructions below to set
the Unit ID and change the remote controller number.
Assign a unique Unit ID on the recorder
1. Press MENU on the front of the DVR or the Remote Controller.
2. Select SYSTEM > RS485 Setup.
3. Enter the desired Unit ID number. See the Unit ID and Remote
Control # table for reference.
Set the number on the Remote Controller
Press and hold the ID button on the remote controller and enter the
corresponding Remote Control number to operate the recorder.
For example, assuming the Unit ID is set to 225, press ID on the remote
controller and then press 2 immediately.
Unit ID and Remote Control #
To use the included remote controller, each recorder needs a unique
Unit ID number that corresponds with a Remote Control number. Use
the table below for reference.
Unit ID 224 225 226 227 228 229 230 231
Remote Control # 1 2 3 4 5 6 7 8
Unit ID 232 233 234 235 236 237 238 239
Remote Control # 9 10 11 12 13 14 15 16