Ubee UBC1301-AA00 Quick Installation Manual

Download Quick installation manual of Ubee UBC1301-AA00 Gateway for Free or View it Online on All-Guides.com.

Brand: Ubee

Category: Gateway

Type: Quick installation manual for Ubee UBC1301-AA00

Pages: 5

Download Ubee UBC1301-AA00 Quick installation manual

Ubee UBC1301-AA00 Quick installation manual - Page 1
1
Ubee UBC1301-AA00 Quick installation manual - Page 2
2
Ubee UBC1301-AA00 Quick installation manual - Page 3
3
Ubee UBC1301-AA00 Quick installation manual - Page 4
4
Ubee UBC1301-AA00 Quick installation manual - Page 5
5
!
www.ubeeinteractive.com
UBC1301-AA00
D3.1 Advanced Wireless Voice Gateway
Quick Installation Guide
Subscriber
Grounding the Device: Install the cable modem to include
grounding the coaxial cable to the earth as close as practical to
the building entrance per ANSI/NFPA 70 and the National
Electrical Code (NEC, in particular, Section 820.93, Grounding of
the Outer Conductive Shield of a Coaxial Cable). The device is
designed for IT power systems with phase-to-phase voltage at
120V.
This unit requires a 100-240V, 50-60Hz power cable. Power cable
must be keyed for proper polarization, and must be fully inserted
to contact the back of the power connector port to ensure snug
connection. Do NOT use any other power cable.
Disconnecting the Device: If the cable modem becomes damaged
or encounters some other abnormality, disconnect the power plug
from the AC wall outlet immediately.
Temperature and Altitude: Install the device in a location not to
exceed the maximum temperature of 104 Fahrenheit (40 Celsius).
Regular operating altitude is 2000 m, and maximum operating
altitude is 4500 m.
SAFETY NOTICES
PREPARING FOR INSTALLATION
Locate the RF (coaxial) cable connector on the wall.
Verify the power outlet is working and is wired correctly. Place
your cable modem within a proper distance from the outlet.
1
UBC1301-AA00
Advanced Wireless Voice Gateway
RJ-45
Analog Phones
RJ-11
Cable/RF
Device must be installed vertically to
obtain optimum wireless performance.
Connect a PC or Ethernet enabled device (wireless
switch or router). A PC should be connected for
initial device installation and configuration.
2
1
3
4
INSTALLING THE MODEM