Yealink W52 Reconfiguration User Manual
Download Reconfiguration user manual of Yealink W52 Cordless Telephone, Handsets for Free or View it Online on All-Guides.com.
Brand: Yealink
Category: Cordless Telephone , Handsets , IP Phone , Telephone
Type: Reconfiguration user manual
Model: Yealink W52 , Yealink W56
Pages: 2
1
2
Yealink W52/W56 DECT IP Phones
Manual Reconfiguration Procedure
BroadSoft BroadCloud PBX 06/01/17
WARNING: THIS PROCEDURE DESCRIBES HOW TO MANUALLY RECONFIGURE YEALINK W52/W56 DECT IP PHONES TO WORK ON THE
BROADSOFT BROADCLOUD PBX NETWORK. ONCE THIS PROCEDURE HAS BEEN COMPLETED, ANY PRIOR CONFIGURATION SETTINGS ON
THE DEVICE WILL BE OVERWRITTEN, INCLUDING THE ADMINISTRATOR PASSWORD, AND THE DEVICE WILL ONLY BE USABLE ON THE
BROADSOFT BROADCLOUD PBX NETWORK. THE DEVICE MUST BE RETURNED TO THE YEALINK FACTORY DEFAULT CONFIGURATION
BEFORE IT CAN BE USED ON ANY NETWORK OTHER THAN BROADSOFT BROADCLOUD PBX.
MINIMUM FIRMWARE REQUIREMENT IS 25.80.0.15 FOR THE BASE STATION. HANDSETS FIRMWARE MAY BE UPGRADED AFTER THE
CONFIGURATION DOWNLOAD.
Factory Default Instructions with Base PIN:
From the handset, performing a default will require the Base PIN. Navigate through the menu by pressing the handset’s OK
key and choosing the following menu selections:
Settings -> System Settings -> Base Reset
Enter the PIN, and the handset will confirm the base reset. (Note: This reset will maintain the handset registrations but
default all other settings.)
Factory Default Instructions without Base PIN:
1. Remove the power from the base station. Long press the paging button and connect the power while maintaining
long press. The LEDs will light up in sequence from bottom to top.
2. Release the paging button and power cycle the base. All handset registrations have now been lost.
3. Register a handset to the base. A two-second long press on the base station, plus following phone prompts will
register the phone with the default Base PIN (0000).
Configuring the Device
1. From a factory default baseline on a Yealink W52/W56 device, determine the IP address through the menu with the
OK button on a paired handset:
OK -> Status -> Base
2. Enter the IP address into your browser to be prompted for login.
3. Log in to the device using the default (case-sensitive) username ("admin") and password ("admin"), and then click
Confirm.
4. Under the Phone tab, click on Auto Provision.
5. Enter the provisioning server address into the Server URL field.
a. For North America, https://yealink.sipflash.com
b. For Europe, http://yealink.broadcloud.eu
c. For Australia, http://yealink.broadcloud.com.au
Note: The secure http applies to North America only.
6. Click Confirm. For European markets, proceed to Step 8.
7. Click Auto Provision Now. This will cause the device to request the files from the provisioning server and reboot. The
provisioning is complete.