York N1VSD10A06 Installation Instruction
Download Installation instruction of York N1VSD10A06 Air Handlers for Free or View it Online on All-Guides.com.
Brand: York
Category: Air Handlers
Type: Installation instruction
Model: York N1VSD10A06 , York N1VSD14A06 , York N2VSD20A06
Pages: 12
1
2
3
4
5
6
7
8
9
10
11
12
GENERAL
This instruction covers the installation of the following variable
speed blower sections.
The blower section is the basic component of an indoor modular
system which may be combined with various accessories listed
below to make an evaporator blower, evaporator blower with
electric heat, heat pump blower, and heat pump blower with
electric heat.
Because of the many ways this Air Handler may be applied and
the large variety of available accessories, the indoor portion of the
cooling or heat pump system comes to you in modules. These
modules must be field assembled to meet the specific needs of
the owner.
If this variable speed air handler is installed with a two stage
(H*DS) outdoor condensing unit, a thermal expansion valve kit
must be installed on the indoor side.
Check modules (accessories, etc.) received, against plans to be
sure all required modules are available for assembly.
INSPECTION
As soon as a unit is received, it should be inspected for possible
damage during transit. If damage is evident, the extent of the
damage should be noted on the carrier’s freight bill. A separate
request for inspection by the carrier’s agent should be made in
writing. See Form 50.15-NM for more information.
REFERENCE
This instruction should be used in conjunction with installation
instructions supplied with each accessory as well as the matching
outdoor section.
Installer should pay particular attention to the words: NOTE,
CAUTION and WARNING.
NOTES
are intended to clarify or make the installation easier.
CAUTIONS
are given to prevent equipment damage.
WARNINGS
are given to alert the installer that personal injury
and/or equipment damage may result if installation procedures
are not handled properly.
®
TYPE OF APPLICATIONS
UPFLOW DOWNFLOW
HORIZONTAL
ELECTRIC FURNACE
WITH 018 - 024 COIL
WITH 030 - 061 COIL
*
*Righthand return may be used by remov ing Horizontal Drain Pan
WITH 024 COIL
FIGURE 1 - Typical Component Application
N1VSD10A06
N1VSD14A06
N2VSD20A06
VARIABLE SPEED AIR HANDLERS
FOR USE WITH SPLIT SYSTEM COOLING AND HEAT PUMP
INSTALLATION INSTRUCTION
Supersedes: 535.03-N1Y (1293)
535.03-N1Y (594)
035-10809
N*VS BLOWER SECTIONS
CAUTION
THE ENCLOSED INSTALLATION INSTRUCTIONS AND ANY APPLICABLE
LOCAL, STATE, AND NATIONAL CODES INCLUDING, BUT NOT LIMITED
TO, BUILDING, ELECTRICAL, AND MECHANICAL CODES.
THIS PRODUCT MUST BE INSTALLED IN STRICT COMPLIANCE W ITH
WARNING
OPERATION OF THE PRODUCT COULD CAUSE PERSONAL INJURY
OR PROPERTY DAMAGE.
INCORRECT INSTALLATION MAY CREATE A CONDITION WHERE THE