ADIC Scalar 100 Quick Start

Download Quick start of ADIC Scalar 100 Storage, Switch for Free or View it Online on All-Guides.com.

Brand: ADIC

Category: Storage , Switch

Type: Quick start for ADIC Scalar 100

Pages: 2 (0.12 Mb)

Download ADIC Scalar 100 Quick start

ADIC Scalar 100 Quick start - Page 1
1
ADIC Scalar 100 Quick start - Page 2
2
®
ADIC Scalar 100 Quick Start Guide
®
2
Beginning with the bottom slot (drive module
1), find the lowest available drive slot(s).
Loosen the two thumbscrews on the filler
plate(s) and remove the filler plate(s).
For AIT libraries, install drives into slots two
through five, beginning with slot two.
If you have drives to install, install them now
by following steps 2 and 3. Otherwise, skip
to step 4.
1
3
Slide the drive(s) into position and tighten
the two captive thumbscrews.
Filler Plate
Drive Module
Captive thumbscrews
7
Install the cables between the bottom drive
and the Library Controller and between the
Library Controller and the host.
If you have more than one SCSI bus,
connect a cable between the bottom drive on
the SCSI bus and the host.
6
Terminate the SCSI bus(es) with an
appropriate terminator (LVD or HVD).
If your library configuration contains a SNC (Storage
Networking Controller), the installation and set-up
must be performed by ADIC-qualified personnel.
Remove the key from the back panel.
Unlock and open the front door. Remove the
interior packing and securing material.
Be sure to remove the rubber band that
secures the picker.
8
On the bottom-most drive, connect a jumper
cable to the top SCSI connector and then to
the bottom SCSI connector on the drive
above it. Repeat this for all the drives.
If you have more than two drives, split the
drives between SCSI buses.
5
4
Depending on your host SCSI bus type, set
the SCSI interface switch to LVD or HVD.
Your library is now ready.
Front Power Switch
11
Turn on the rear power switch and then turn
on the front power switch.
Install tape cartridges into magazines. Close
and lock the front door.
9
10
Connect the power cord to the power outlet
on the rear of the library.
Power up your host system and verify
communication with all devices on the bus.
12
LVD SCSI
Connections
Rear Power
Switch
Drive to
Library Controller
Library
Controller
to Host
Optional
SNC
Terminator
Jumper Cable
Power Cord
Library
to Host
SCSI Interface
Switch
HVD SCSI
Connections
6-00671-01 Rev A