Sony LA-FZB2 Operation Manual

Download Operation manual of Sony LA-FZB1 Adapter for Free or View it Online on All-Guides.com.

Brand: Sony

Category: Adapter

Type: Operation manual

Model: Sony LA-FZB1 , Sony LA-FZB2

Pages: 2

Download Sony LA-FZB1 Operation manual

Sony LA-FZB1 Operation manual - Page 1
1
Sony LA-FZB1 Operation manual - Page 2
2
日本語
安全のために
ソニー製品は安全に充分に配慮して設計されています。しかし、まちがった使い
かたをすると、落下などにより人身事故につながることがあり、危険です。
事故を防ぐために次のことを必ずお守りください。
安全のための注意事項を守る。
故障したり破損したら使わずに、ソニーのサービス窓口に相談する。
警告表示の意味
は、
をしています。表示の内容をよく理解してから
文をお読みください。
と、
どにより死亡や大けがなど人身事故につながるこ
とがあります。
と、
の事故によりけがをしたり周辺の物品に損害を与
えたりすることがあります。
注意を促す記号
行為を指示する記号
下記の注意を守らないと、
火災
感電、
落下
により
死亡
大けが
につながること
があります。
太陽光や輝度の高い光源にレンズを向けて覗かない
目を傷める恐れがあります。
下記の注意を守らないと、
けが
をしたり、周辺
の物品に
損害
を与えることがあります。
取り付け時にカメラ側とレンズ側のマウントリングを確実に締め
ネジの締め付けが不充分な場合、本機が落下し、けがをする原因とな
ることがあります。
指定されたカメラに取り付け、指定されたレンズを取り付ける
指定以外のカメラに取り付けると、しっかりと固定されないため本機
が落下し、足などにけがをする原因となることがあります。
保管中は必ず前後のマウントキャップを取り付ける
太陽光の集光による火災を防ぐため、本機を保管するときは、必ずマ
ウントキャップを取り付けてください。
使用上のご注意
本機の内部を触らないでください。やむを得ずゴミがついた場合は、ブロアを
お使いください。
本機を装着するときやご使用になる際には、衝撃を与えないようにご注意くだ
さい。
レンズの交換は、ゴミやほこりの少ない場所で行ってください。
レンズ信号接点を触らないでください。よごれ等により接触不良になると、
メラとの信号のやりとりが正しく行われず、カメラが正しく動作しなくなりま
すのでご注意ください。
保管について
必ず本機にマウントキャップを取り付けてください。
湿度の高い場所に長期間置かないでください。カビが発生することがありま
す。
結露について
本機を寒いところから急に暖かいところに持ち込んだときなど、機器表面や内部
に水滴がつくことがあります。これを結露といいます。結露が起きたときは電
を切り、結露がなくなるまで放置し、結露がなくなってからご使用ください。
結露時のご使用は機器の故障の原因となる場合があります。
お手入れについて
お手入れには、シンナー、ベンジンなどの有機溶剤は絶対に使わないでください。
主な仕様
外形寸法
(幅/高さ/奥行き)
LA-FZB2
91 mm
×
114 mm
×
96 mm
(突起部含まず)
最外形:約
92 mm
×
114 mm
×
96 mm
レンズサポート込み:約
105 mm
×
173 mm
×
96 mm
LA-FZB1
91 mm
×
91 mm
×
95 mm
(突起部含まず)
レンズサポート込み:約
105 mm
×
151 mm
×
95 mm
質量
LA-FZB2
840 g
レンズサポート
/
サポートロッド込み:約
960 g
LA-FZB1
670 g
レンズサポート込み:約
760 g
付属品 マウントキャップ
B4
1
マウントキャップ
FZ
1
レンズサポート
1
接続軸
1
、φ
15
ロッド
LA-FZB2
のみ)
2
取扱説明書
1
保証書
1
仕様および外観は、改良のため予告なく変更することがありますが、ご了承くだ
さい。
この装置は、クラス
A
情報技術装置です。この装置を家庭環境で使用すると電
波妨害を引き起こすことがあります。この場合には使用者が適切な対策を講ず
るよう要求されることがあります。
VCCI-A
お使いになる前に、必ず動作確認を行ってください。故障その他に伴う営業
上の機会損失等は保証期間中および保証期間経過後にかかわらず、補償はい
たしかねますのでご了承ください。
本製品を使用したことによるお客様、または第三者からのいかなる請求につ
いても、当社は一切の責任を負いかねます。
諸事情による本製品に関連するサービスの停止、中断について、一切の責任を
負いかねます。
保証書とアフターサービス
保証書
この製品には保証書が添付されていますので、お買い上げの際お受け取りくだ
さい。
所定の事項の記入および記載内容をお確かめのうえ、大切に保存してくださ
い。
アフターサービス
調子が悪いときはまずチェックを
この説明書をもう一度ご覧になってお調べください。
それでも具合が悪いときは
お買い上げ店、またはソニーのサービス窓口にご相談ください。
保証期間中の修理は
保証書の記載内容に基づいて修理させていただきます。詳しくは保証書をご覧
ください。
保証期間経過後の修理は
修理によって機能が維持できる場合、ご要望により有料修理させていただきま
す。保証期間中の修理など、アフターサービスについてご不明な点は、お買い上
げ店、またはソニーのサービス窓口にお問い合わせください。
English
Before operating the unit, please read this manual thoroughly and retain
it for future reference.
For the customers in the U.S.A.
This equipment has been tested and found to comply with the limits for a Class A
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference when the equipment
is operated in a commercial environment. This equipment generates, uses, and
can radiate radio frequency energy and, if not installed and used in accordance
with the instruction manual, may cause harmful interference to radio
communications. Operation of this equipment in a residential area is likely to
cause harmful interference in which case the user will be required to correct the
interference at his own expense.
You are cautioned that any changes or modifications not expressly approved in
this manual could void your authority to operate this equipment.
All interface cables used to connect peripherals must be shielded in order to
comply with the limits for a digital device pursuant to Subpart B of part 15 of FCC
Rules.
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference,
and (2) this device must accept any interference received, including interference
that may cause undesired operation.
For the customers in Canada
CAN ICES-3 (A)/NMB-3(A)
4-480-312-01(1)
© 2013 Sony Corporation
Printed in Japan
Mount Adapter
LA-FZB2
LA-FZB1
取扱説明書
Operation Guide
お買い上げいただきありがとうございます。
安全のための注意事項を守らないと、けがをしたり、周辺の物品に損害
を与えることがあります。
この取扱説明書には、事故を防ぐための重要な注意事項と製品の取り扱いかたを示し
てあります。この取扱説明書をよくお読みのうえ、製品を安全にお使いください。お読
みになったあとは、いつでも見られるところに必ず保管してください。
For the customers in Europe
This product with the CE marking complies with the EMC Directive issued by the
Commission of the European Community.
Compliance with this directive implies conformity to the following European
standards:
EN55103-1: Electromagnetic Interference (Emission)
EN55103-2: Electromagnetic Susceptibility (Immunity)
This product is intended for use in the following Electromagnetic Environments:
E1 (residential), E2 (commercial and light industrial), E3 (urban outdoors), E4
(controlled EMC environment, ex. TV studio).
For the customers in Europe
This product has been manufactured by or on behalf of Sony Corporation, 1-7-1
Konan Minato-ku Tokyo, 108-0075 Japan. Inquiries related to product
compliance based on European Union legislation shall be addressed to the
authorized representative, Sony Deutschland GmbH, Hedelfinger Strasse 61,
70327 Stuttgart, Germany. For any service or guarantee matters, please refer to
the addresses provided in the separate service or guarantee documents.
Notes on Use
Do not touch the inside of this unit. If there is any dirt on the translucent
mirror or the inside of this unit, remove it with a blower brush.
Be careful not to subject this unit to mechanical shock while attaching and
using it.
Avoid changing the lens in dusty or dirty locations.
Do not touch the lens contacts. Any dirt on the lens contacts may interfere
with the sending and receiving of signals between the lens and the camera,
resulting in operational malfunction.
Storing this unit
Always place the mount cap on this unit.
To prevent mold, do not keep this unit in a very humid place for a long time.
Condensation
If the unit is suddenly taken from a cold to a warm location, or if ambient
temperature suddenly rises, moisture may form on the outer surface of the unit
and/or inside of the unit. This is known as condensation. If condensation occurs,
turn off the unit and wait until the condensation clears before operating the unit.
Operating the unit while condensation is present may damage the unit.
Cleaning this unit
Do not use any organic solvent such as thinner or benzine to clean this unit.
Specifications
Dimensions
(w/h/d)
LA-FZB2
Approx. 91 mm × 114 mm × 96 mm (excluding the
projecting parts) (3
5
/8 in × 4
1
/2 in × 3
7
/8 in)
Maximum dimensions: Approx. 92 mm × 114 mm ×
96 mm (3
5
/8 in × 4
1
/2 in × 3
7
/8 in)
With a lens support: Approx. 105 mm × 173 mm ×
96 mm (4
1
/4 in × 6
7
/8 in × 3
7
/8 in)
LA-FZB1
Approx. 91 mm × 91 mm × 95 mm (excluding the
projecting parts) (3
5
/8 in × 3
5
/8 in × 3
3
/4 in)
With a lens support: Approx. 105 mm × 151 mm ×
95 mm (4
1
/4 in × 6 in × 3
3
/4 in)
Mass LA-FZB2
Approx. 840 g (1 lb 14 oz)
With a lens support/support rod: Approx. 960 g (2 lb
2 oz)
LA-FZB1
Approx. 670 g (1 lb 8 oz)
With a lens support: Approx. 760 g (1 lb 11 oz)
Supplied items Mount cap (B4) (1), Mount cap (FZ) (1), Lens support
(1), Knob (1), ø15 rod (LA-FZB2 only) (2), Operation
guide (1), Warranty (1)
Design and specifications are subject to change without notice.
Notes
Always verify that the unit is operating properly before use. SONY WILL NOT
BE LIABLE FOR DAMAGES OF ANY KIND INCLUDING, BUT NOT LIMITED TO,
COMPENSATION OR REIMBURSEMENT ON ACCOUNT OF THE LOSS OF
PRESENT OR PROSPECTIVE PROFITS DUE TO FAILURE OF THIS UNIT, EITHER
DURING THE WARRANTY PERIOD OR AFTER EXPIRATION OF THE WARRANTY,
OR FOR ANY OTHER REASON WHATSOEVER.
SONY WILL NOT BE LIABLE FOR CLAIMS OF ANY KIND MADE BY USERS OF
THIS UNIT OR MADE BY THIRD PARTIES.
SONY WILL NOT BE LIABLE FOR THE TERMINATION OR DISCONTINUATION OF
ANY SERVICES RELATED TO THIS UNIT THAT MAY RESULT DUE TO
CIRCUMSTANCES OF ANY KIND.