Wattstopper LVSW-101 Installation Instructions

Download Installation instructions of wattstopper LVSW-101 Switch for Free or View it Online on All-Guides.com. This version of wattstopper LVSW-101 Manual compatible with such list of devices, as: LVSW-101, LVSW-102, LVSW-103, LVSW-104, LVSW-108

wattstopper LVSW-101 Installation instructions - Page 1
1
wattstopper LVSW-101 Installation instructions - Page 2
2
LVSW-101/102/103/104/108
Low Voltage Switch
Voltage, from panel .............................................. 24VDC, Class 2
Maximum Contact Current Per Button ............................... 50mA
Maximum Operating Current ................................................ 2mA
Wire Connections; Removable Terminal Blocks
Use 18 -22 AWG Copper Conductors Only
One terminal per button
One terminal per LED
Two common terminals; shared with all buttons and LEDs
Environment ................................................. For Indoor Use Only
Operating Temperature ....................32° to 130°F (0° to 55°C)
Relative Humidity ........................... 5 to 95% (non condensing)
UL and cUL listed
Installation Instructions
LVSW-108LVSW-104LVSW-103LVSW-102LVSW-101
The LVSW series low voltage switch is intended for use with
lighting control devices that expect a momentary contact
closure to toggle the state of the lighting load. Each button
on the LVSW switch has an LED indicator intended to display
the current state of the lighting load when connected
appropriately to the lighting control device. Five color kits and
custom engraving options are available.
WIRING
P2
1
1
P1
COM
SW1
SW2
SW3
SW4
SW5
SW6
SW7
SW8
COM
LED1
LED2
LED3
LED4
LED5
LED6
LED7
LED8
Common
Switch button
Button LED
SPECIFICATIONS
1. Connect the “Com” terminal (common) of the LVSW switch to the lighting control
device per the instructions provided with the device. Note that both “Com” terminals
on the LVSW switch are internally connected together.
2. Connect the terminal corresponding to the button on the LVSW switch (SW1 –SW8) to
the input of the lighting control device per the instructions provided with the lighting
control device.
3. Connect the terminal corresponding to the LED pilot light on the LVSW button (LED1 –
LED8) to the pilot light output of the control device per the instructions provided with
the lighting control device.
4. Repeat for all buttons on the switch. Refer to diagram for button-terminal cross
reference.
5. Install the LVSW switch into a single gang wall box or one position in a multi-gang
switch box using the mounting screws provided with the LVSW switch. Be careful to
press the low voltage wires into the box so they are not pinched by the mounting plate.
6. Install an appropriate switch cover plate (not supplied) over the LVSW switch to
complete the installation.
MOUNTING THE SWITCH
BUTTONS AND INDICATORS
On/Off button
Blue LED
WARNING: Do Not install To Cover Junction Box Having Class 1,
3 or Power and Lighting Circuits.
WARNING  For install in UL Listed Junction Box or Enclosure
Containing Only Class 2 Wiring - Do not Reclassify and Install as
Class 1, 3 or Power and Lighting Wiring.
Back View