Microscan IB-3 PC Quick Start Manual
Download Quick start manual of Microscan IB-3 PC Adapter for Free or View it Online on All-Guides.com.
1
Quick Start Guide, IB-3 PC
Setup for Keyboard Wedge
SCANNER
1
2
3
2 CONFIG.
HOST/SERIAL
98-000049-01
1 SERIAL
COMM.
3 KEYBOARD
WEDGE
KEYBRD OUT/
POWER IN
KEYBOARD IN
IB-3PC
4
2
1
3
83-210039 Rev C
MS-3 Laser Scanner Setup
1. Scan the configuration symbols in frame 4 in
order, pausing for a second or two on each until
you hear a beep (except for step 4, “Enable all
Symbologies,” which does not generate a beep).
2. Mount your scanner in the position that is suit-
able for your application and begin operations.
When scanning, you have five seconds to read a
symbol and move on before it is read again.
Note: Setup symbols for the MS-3 Laser Scanner
in the next two frames are presen
ted at right
angles to each other in order to prevent accidental
scanning of the wrong command.
Required Hardware
1. IB-3 PC, P/N FIS-0001-0030G
2. MS-3 Laser Scanner
3. Customer-supplied keyboard
4. Host computer
Steps for Connection and Startup
1. Power-off your host computer.
2. Set the IB-3 PC switch to
position 1.
3. Connect the scanner (2)
and the keyboard (3) to
the IB-3 PC as shown.
4. Plug the IB-3 PC cable
directly into the host com-
puter’s (4) keyboard port.
5. Power-on host computer.
6. Open a word processor or
text editor to see scanned
data.
SCANNER
1
2
3
2 CONFIG.
HOST/SERIAL
98-000049-01
1 SERIAL
COMM.
3 KEYBOARD
WEDGE
KEYBRD OUT/
POWER IN
KEYBOARD IN
IB-3PC
Position 1
MS-3 Laser Scanner Configuration Symbols
1. Enable configuration mode.
2. Enable Continuous Read 1.
3. Set 5 second timeout.
4. Enable all symbologies (no beep on this one).
5. Save for power-on.
MS- CCD Setup
The two symbols to the
right will setup the
MS-2 CCD for reading
with the IB-3 PC.
Note: There is no
beeper on the MS-2
CCD but whenever a
good read occurs the
reader’s LED will
momentarily turn OFF
and then ON and the
Good Read lamp will
flash ON and OFF.
Enable all
Symbologies
Set Read
Mode
MS-2 CCD Symbols
Te s t S y m b o l
The following bar code symbol can be used to test
the operation of the setup:
Note: Download a copy of the IB-3 PC User
Manual, P/N 83-210037, for a complete
description of the IB-3 PC and its capabilities.
Note: Also see the MS-3 Laser Scanner User
Manual, P/N 83-000003.
1 2 3 4
23
456