HP StoreVirtual P4000 G2 Installation Instructions Manual
Download Installation instructions manual of HP StoreVirtual P4000 G2 Storage for Free or View it Online on All-Guides.com.
Brand: HP
Category: Storage
Type: Installation instructions manual for HP StoreVirtual P4000 G2
Pages: 3
Download HP StoreVirtual P4000 G2 Installation instructions manual
1
2
3
HP StoreVirtual P4000 G2
Memory Module Installation
Instructions
Abstract
This document describes how to install the HP StoreVirtual
P4000 G2 Memory Module for HP P4000 G2 storage
systems.
© Copyright 2015 Hewlett-Packard Development Company, L.P.
*B7E22-96003*
HP Part Number: B7E22-96003
Published: July 2015
Edition: 3
Overview
Follow the procedures for your environment (upgrading
one or multiple storage systems):
• Upgrading a single storage system—Continue
with “Installing the memory module” (page 1).
• Upgrading multiple storage systems in a
management group—To save restripes of volume
data, HP recommends shutting down the
management group, which puts it into
maintenance mode. Then you can upgrade
multiple storage systems and safely restart all the
storage systems to bring the management group
back online. See “Safely shutting down a
management group” (page 3) and then follow
the steps in “Installing the memory module”
(page 1).
Installing the memory module
1. Have the following items ready:
• Memory module
• T-10 wrench
2. Power down the storage system, using the CMC:
a. Log in to the storage system.
b. Right–click the storage system and select
Power Off or Reboot.
c. In the window that opens, select Power off.
Alternatively, you can power down the system by
quickly pressing and releasing the storage system
power button two times.
3. Extend the storage system from the rack:
a. Disconnect all peripheral cables and power
cords.
b. Loosen the front panel thumbscrews.
c. Extend the storage system on the rack rails
until the storage system rail-release latches
engage.
WARNING! To reduce the risk of
personal injury or equipment damage,
be sure that the rack is adequately
stabilized before extending a
component from the rack.
4. Remove the storage system from the rack and
place it on a sturdy, level surface.
5. Use a wrist strap connected to the work surface,
and properly grounded (earthed) tools and
equipment.
Page 1